312001142 - E7020 ABS - DESCRIPTION

DESCRIPTION

The ABS electronic anti-lock braking system regulates the braking pressure transmitted to the wheels, preventing them from losing grip whatever the tyre and road conditions.The system is designed to be incorporated with the braking system (using the same hydraulic fluid) without preventing the operation of the actual braking system if the ABS fails.Four sensors, located on each of the four wheels, indicate the speed of each wheel to the electronic control unit, recording any situations involving locking, slipping or loss of grip.In these situations, the control unit controls the solenoid valves which modulate the pressure in the hydraulic circuit, preventing the wheels from locking and restoring grip conditions for the vehicle. This ensures optimum handling of the vehicle and excellent stopping distances.The sensors are the "active" type, supplied by the control unit; they consist of a magnetic resistive receiver with a magnetic codifier incorporated in the hub bearing so that the signal is less affected by electromagnetic interference and variations in temperature.The ABS control unit also controls the distribution of the braking load between the front and rear axles, meaning that the mechanical load proportioning valve used previously can be dispensed with (EBD function: Electronic Brake Distribution ).The control unit is equipped with a self-diagnostic function: when an error in the ABS function is detected, the warning light comes on and the system is deactivated at the same time. In these conditions the vehicle brakes using the traditional system only.When the control unit detects an error which also affects the EBD function, it turns on the "ABS failure" warning light and the "low brake fluid and handbrake" warning light.

In these conditions the rear braking distribution control is deactivated: the driver must therefore proceed very carefully to the first authorised service centre.

Messages concerning the operational faults are also shown on the multifunctional display.The ABS control unit calculates the speed of the vehicle starting from the figures that are supplied by the drive wheel sensors (with the ABS control unit calculating the average value) and from the circumference of the wheels themselves, supplied by the Body Computer: this speedometer signal is then sent, via the CAN, to the nodes that require this information.The direct battery supply lines for the control unit (pump and solenoid valves) are protected by two dedicated fuses located in the engine compartment junction unit; the ignition-controlled power supply is protected in the same way by a dedicated fuse.For more details,    See descriptions 3340 ANTI-LOCK BRAKING SYSTEM (ABS)

Following sharp braking which causes considerable deceleration, the Body Computer, having received the vehicle speed signal from the ABS control unit, activates the hazard warning lights. When this deceleration value goes below a pre-set level, the hazard function is automatically deactivated.

    See E2020 DIRECTION INDICATORS / HAZARD WARNING LIGHTS