312002087 - 7210B61 R.R. BOOT FLOOR PAN SIDE MEMBER - PARTIAL

Removing ( Refitting )     Op. 7210B82 R.R REAR CROSSMEMBER     Op. 7210B70 R.R. REAR TRIM (STRUCTURAL ELEMENT)     Op. 7210B56 R.R. BOOT LOAD COMPARTMENT FLOOR PLAN (PARTIAL REAR INTERVENTION) - Ensure that the components connected are not distorted by checking the body alignment measurements with suitable equipment (reference rigs, templates or gauges).- Straighten the body as necessary. 1. Use a jigsaw following the cutting lines shown in the diagram. - Work in the rear zone of the rear wheel compartment.- Use a rotary brush to remove the paint and gain access to the spot welds 1. Use the drill to chamfer the spot welds shown in the diagram.- Use a hammer and chisel to remove the previously chamfered spot welds and remove the side member part. - Straighten the edges of the vehicle using a hammer and dolly block.- Remove the spot weld residues using a disc grinder.- Use a rotary brush to clean the previously treated areas. 1. Apply electro-weldable paint in the areas shown in the diagram. Refitting ( Removing ) 1. Use the jig saw following the cutting lines shown in the diagram to cut from the spare part a section the same length as the previously removed part. 1. Remove the anti-corrosion treatment from the area shown in the diagram with a rotary brush.- Apply electroweldable paint to the areas involved. 1. Position the replacement part correctly on the vehicle and secure it using self-locking clamps.- Check the alignment.2. Carry out the seam welding in the indicated area, using the MIG welder - Work in the rear zone of the rear wheel compartment. 1. Use the seam welder and fill weld in the openings indicated in the diagram. - Use a rotary brush to clean the previously welded areas.- Apply rustproofing to the areas involved in the welding    Op. 7210B56 R.R. BOOT LOAD COMPARTMENT FLOOR PLAN (PARTIAL REAR INTERVENTION)     Op. 7210B82 R.R REAR CROSSMEMBER     Op. 7210B70 R.R. REAR TRIM (STRUCTURAL ELEMENT)