312003033 - 7055C01 ADHESIVE STRIPE ON REAR WING (ONE), LEFT OR RIGHT - R.R.

Removing ( Refitting )

The stickers should be removed and fitted at ambient temperature and the bodywork should be cleaned first.

1. Heat the sticker with a hot air blower.

Carry out the operation for a length of about 20 centimetres.

1. Remove the part of the sticker heated previously. - Repeat the operation several times along the entire length of the sticker.- Clean the residual adhesive using the special product - 3m Cleaner Spray. Refitting ( Removing ) - Clean the area where the sticker will be fitted using a cloth. 1. Place the sticker on the rear wing using the lower edge of the glass scraper (1a) as the upper reference and the edge of the door (1b) as the side reference.

let the adhesive section overlap about 5 mm beyond the front profile of the wing to allow it to be turned over later on.

- If necessary, secure the position of the sticker using adhesive tape. 1. Remove the lower protective film starting from the front of the sticker and stick the sticker to the rear wing taking care not to produce bubbles or folds. 1. With the help of the buffer stick the sticker working gently from the middle towards the top and from the middle towards the bottom. - Remove the upper protective film for the sticker.

handle the stickers carefully: check for stretching, distortions or breaks.

- With the help of the buffer extend the sticker along its entire length. 1. Turn the sticker over and stick it to the front edge of the rear wing.

If there are bubbles in the stickers are they have been fitted, pierce them using a needle and stretch them again over the surrounding area using the special spatula.

Keep the vehicle under cover for at least one hour after fitting the stickers.

Avoid washing the vehicle for 24 hours after the stickers have been fitted.