It is the variable geometry type and is connected to the exhaust manifold; it is designed to increase the volumetric efficiency of the engine.Variable geometry type turbochargers are composed of:- a centrifugal compressor- a turbine- a series of moving vanes- a pneumatic actuator controlling the moving vanes.The management of the operation of the turbocharger variable geometry is controlled by the control unit through the operation of the VGT solenoid.
1. Engine management control unit2. VGT solenoid3. Vacuum tank4. Moving vane control actuator5. TurbochargerThe variable geometry turbocharger makes it possible to:- increase the speed of the exhaust gases in the turbine at low engine speeds- slow down the speed of the exhaust gases in the turbine at high speeds.Controlling the speed (kinetic energy) of the exhaust gases allows for:- increased engine torque at low speeds- increased maximum power at high speeds.Operation at high rotation speedsAs the rotation speed of the engine increases, there is a gradual increase in the kinetic energy of the exhaust gases.As a result, the speed of the turbine (1) and, consequently the supercharging pressure, which also acts on the actuator (3), increases.The actuator (3), controlled by the solenoid valve, opens the moving vanes (2) by means of a rod, until the maximum opening position is reached.The increase in the section produces a slowing down of the flow of the exhaust gases passing through turbine (1) at speeds which are the same as or less than the low speed condition.The speed of turbine (1) decreases and settles down at a suitable level for the correct operation of the engine at high speeds.
1. Turbine2. Moving vanes3. Pneumatic actuator4. Rotary sealOperation at low rotation speedsWhen the engine is running at a low rotation speed, the exhaust gases possess little kinetic energy; under these circumstances a traditional turbine would turn slowly, providing limited turbocharging pressure.In variable geometry turbine (1) on the other hand, moving vanes (2) are in the maximum closed position and the small sections between the vanes increase the speed (C) of the exhaust gases.Greater intake speeds result in greater peripheral speeds (U) for the turbine and, consequently, the compressor.The speed of the gases inside the impeller is indicated by the vector (W).
1. Turbine2. Moving vanes3. Pneumatic actuator4. Rotary seal
