323000131 - 7005A14 FRONT SIDE DOOR - ADJUST CENTERING AND MOULDING - INCLUDES ADAPTATION OF HINGES AND SEALS ON DOOR COMPARTMENT

1. If the adjustment is carried out after having removed the door, tighten the hinge bolts to the recommended torque.
Component Fasteningdia  Value (daNm)Validity
Moving hinges on fixedBoltM82.2 ÷ 2.6
    Op. 7005B14 FRONT SIDE DOOR LOCK STRIKER - R.R - If necessary, provisionally tighten the bolts securing the hinges to the door and body.2. Unscrew check strap bolt (2a) and close the door temporarily to return link (2b).
- Initially adjust the door within the door compartment. To do this, the bolts securing the hinges to the body must be loosened.- The crossmember supporting the dashboard trim must be removed to undo the upper hinges. Carry out the following operations, including all preliminary operations.    Op. 7040A97 INSTRUMENT PANEL TRIM SUPPORTING CROSSMEMBER - R.R - Proceed as follows to undo the lower hinges.    Op. 7040L48 FRONT AND REAR DOOR RUNNING BOARD (ONE), LEFT OR RIGHT - R.R.    Op. 7040L42 FRONT DOOR RUNNING BOARD CONNECTOR (ONE), LEFT OR RIGHT - R.R. 1. Loosen bolts (1a) securing hinges (1b) to body.2. Adjust the door position by means of the slotted bolt holes until it is correctly aligned in the door compartment.
It is advisable to work on one hinge at a time. The arrows indicate the possible movements for the adjustment.
3. After adjustment, tighten the bolts to the specified torque.
Component Fasteningdia  Value (daNm)Validity
Door hinges to bodyBoltM82.9 ÷ 3.5
- Refit the components removed in order to access the bolts securing the hinge.    Op. 7040L42 FRONT DOOR RUNNING BOARD CONNECTOR (ONE), LEFT OR RIGHT - R.R.     Op. 7040L48 FRONT AND REAR DOOR RUNNING BOARD (ONE), LEFT OR RIGHT - R.R.- If necessary, align the door with the wing and rear door as follows.- Open the door.1. Loosen bolts (1a) securing hinges (1b) to body.2. Adjust the door position by means of the slotted bolt holes until it is correctly aligned with the wing and front door.
It is advisable to work on one hinge at a time. The arrows indicate the possible movements for the adjustment.
3. After adjustment, tighten the bolts to the specified torque.
Component Fasteningdia  Value (daNm)Validity
Hinges to doorBoltM104.0 ÷ 4.9
4. Remove link (4a) and tighten bolt (4b) to the specified torque.
Component Fasteningdia  Value (daNm)Validity
Door detent link (body side)BoltM82.25 ÷ 2.75
- Refit and adjust the door striker.    Op. 7005B14 FRONT SIDE DOOR LOCK STRIKER - R.R - Touch up the paint in the hinge half area.- Check that the striker and the door lock are correctly matched and that the alignment is correct with the door closed.