323001094 - 3330C10 MASTER CYLINDER (PUMP) - R + R

Removing ( Refitting ) - Disconnect the negative battery terminal.    Op. 5530B10 BATTERY - R+R     Op. 5530B52 BATTERY SUPPORT/DRIP TRAY - R.R - Unscrew the brake-clutch fluid reservoir plug and fit the tool.

Tool	Description	Function	Validity
2000001400	Plug	Brake/ clutch system vacuum

1. Connect a suitable container to the bleed valve of one front brake caliper.2. Loosen the bleed valve and pump the brake pedal several times to drain the fluid out of the brake fluid reservoir. 1. Disconnect the electrical connection for the brake fluid minimum level warning light switch.

	Description	Connector
1	Brake fluid level sensor (switch)	See K025 BRAKE FLUID LEVEL SENSOR (SWITCH)

1. Disconnect the brake pump system supply pipe.2. Undo the connectors for the rigid fluid pipes from the master cylinder.3. Undo the nuts (3a) and remove the master brake cylinder (3b) complete with reservoir (3c). 1. Act on the clips (1a) and remove the oddments compartment assembly (1b). Refitting ( Removing ) - Install the master cylinder on the reservoir and do up the clips.- Place the master cylinder in its housing complete with brake fluid reservoir and tighten the nuts to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Master brake cylinder (pump)	Nut	-	1.7 ÷ 2.3

- Tighten the fittings on the rigid pipes from the master cylinder to the electrohydraulic control unit to the specified torque.

Component	Fastening	dia	Value (daNm)	Validity
Brake pipe connectors	Connector	M10	1.4 ÷ 1.8

- Connect the system supply pipe to the clutch pump.- Connect the electrical connection to the brake fluid minimum level warning light switch.    Op. 5530B52 BATTERY SUPPORT/DRIP TRAY - R.R     Op. 5530B10 BATTERY - R+R     Op. 0010T64 BRAKE AND/OR CLUTCH FLUID CHECK LEVEL AND TOP UP AS NECESSARY     Op. 0010T65 HYDRAULIC BRAKE SYSTEM - BLEED AIR - Connect the negative battery terminal (-).