4450D14 STUB AXLE FOR ONE REAR WHEEL HUB, LEFT OR RIGHT - R.R WITH HUB REMOVED - INCLUDES BUSH REPLACEMENT IF NECESSARY - CHECK WHEEL GEOMETRY SEPARATELY - Fiat - LINEA - eLearn

323002047 - 4450D14 STUB AXLE FOR ONE REAR WHEEL HUB, LEFT OR RIGHT - R.R WITH HUB REMOVED - INCLUDES BUSH REPLACEMENT IF NECESSARY - CHECK WHEEL GEOMETRY SEPARATELY

) Op. 7040L22 REAR COVER ON TUNNEL - R.R.1. Loosen the handbrake lever cable adjustment nut.

1. Remove the protective cover.2. Disconnect the parking brake control cable from the attachment on the drum.3. Undo the connector for the rear brake pipe.

1. Undo the bolts (1a) and remove the drum brake assembly (1b).

1. Undo bolt (1a) and remove ABS rpm sensor (1b).2. Undo bolts (2a) and remove stub axle strut (2b).

Refitting ( Removing

) - Fit the stub axle in its seat and tighten the bolts to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Rear wheel strut	Bolt	M12	12 ÷ 13

- Position the ABS rpm sensor in its housing and secure it using the bolt.- Fit the drum brake assembly in its seat and tighten the bolts to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Drum brake assembly	Bolt	M8	3.8 ÷ 4.2	1.4 8v1.3 Multijet

- Connect the connector for the rear brake pipe.- Connect the parking brake control cable to the attachment on the drum.- Place the protective cover in its housing. Op. 3380A04 HANDBRAKE - ADJUST TRAVEL Op. 7040L22 REAR COVER ON TUNNEL - R.R.