323002139 - 4450A40 REAR WHEEL GEOMETRY - CHECK USING OPTICAL EQUIPMENT, INCLUDES ADJUSTMENT IF NECESSARY
- This check procedure must be carried out after each operation on the rear suspension mechanical components since its purpose is to define the position of the wheel in relation to the body (e.g.: struts, shock absorbers, springs etc.). OPERATING CYCLEIntroductionThe wheel geometry/angle checks must be carried out using appropriate optical equipment after checking and adjusting tyre inflation pressure to the specified values and ensuring that the vehicle respects one of the following load conditions:- “Standard 0” - vehicle unladen including spare wheel, tools, accessories and consumables with 5 litres of fuel- “Standard A” - vehicle unladen including spare wheel, tools, accessories and consumables (full tank of fuel). GEOMETRY CHECK- Check that the geometry of the rear wheels is within recommended values; to measure the geometry, check the distance from the ground to the maximum point of curvature on the rear wing (protrusion).| Measurement | Value | Validity |
|---|---|---|
| Rear geometry - Protrusion height (mm) | 692 +/- 5(Standard A) | 1.4 8v |
| Measurement | Value | Validity |
|---|---|---|
| Rear geometry - Protrusion height (mm) | 699 +/- 5(Standard 0) | 1.4 8v |
| Measurement | Value | Validity |
|---|---|---|
| Rear geometry - Protrusion height (mm) | 686 ± 5(Standard A) | 1.4 16v TJET |
| Measurement | Value | Validity |
|---|---|---|
| Rear geometry - Protrusion height (mm) | 692 ± 5(Standard 0) | 1.4 16v TJET |
| Measurement | Value | Validity |
|---|---|---|
| Rear geometry - Protrusion height (mm) | 689 +/- 5(Standard A) | 1.3 Multijet Active |
| Measurement | Value | Validity |
|---|---|---|
| Rear geometry - Protrusion height (mm) | 696 +/- 5(Standard 0) | 1.3 Multijet Active |
| Measurement | Value | Validity |
|---|---|---|
| Rear geometry - Protrusion height (mm) | 686 +/- 5(Standard A) | 1.3 MultijetDynamic |
| Measurement | Value | Validity |
|---|---|---|
| Rear geometry - Protrusion height (mm) | 692 +/- 5(Standard 0) | 1.3 MultijetDynamic |
| Measurement | Value | Validity |
|---|---|---|
| Rear wheel toe in (mm) | +1.7 +/- 1(Standard A and Standard 0) |
| Measurement | Value | Validity |
|---|---|---|
| Rear wheel camber (degrees) | -37’ +/- 20’(Standard A) | 1.4 8v |
| Measurement | Value | Validity |
|---|---|---|
| Rear wheel camber (degrees) | -36’ +/- 20’(Standard 0) | 1.4 8v |
| Measurement | Value | Validity |
|---|---|---|
| Rear wheel camber (degrees) | -38’ ± 20’(Standard A) | 1.4 16v TJET |
| Measurement | Value | Validity |
|---|---|---|
| Rear wheel camber (degrees) | -37’ ± 20’(Standard 0) | 1.4 16v TJET |
| Measurement | Value | Validity |
|---|---|---|
| Rear wheel camber (degrees) | -37’ +/- 20’(Standard A and Standard 0) | 1.3 Multijet |