323002934 - 7210A46 R R (COMPLETE) UPPER FRONT STRUT (ONE) LH OR RH
Removing
(
Refitting
)
Op. 7210E20 R.R. BONNET Op. 7210E36 R.R. FRONT SIDE DOOR Op. 7210E18 R.R. FRONT WING - Ensure that the components connected are not distorted by checking the body alignment measurements with suitable equipment (reference rigs, templates or gauges).- Straighten the body as necessary.1. Grind the seam weld shown in the figure.- Use a rotary brush to remove the paint and gain access to the spot welds.2. Use the chamfering machine to remove the spot welds shown in the diagram.- Use a hammer and chisel to remove the previously chamfered spot welds.3. Remove the outer part of the component
1. Use the jig saw, following the cutting line in the diagram.- Use a rotary brush to remove the paint and gain access to the spot welds.2. Use the chamfering machine to remove the spot welds shown in the diagram.- Use a hammer and chisel to remove the previously chamfered spot welds.3. Remove the inner part of the component.
- Straighten the edges of the vehicle using a hammer and dolly block.- Remove the spot weld residues using a disc grinder.- Use a rotary brush to clean the previously treated areas.1. Apply electro-weldable paint.
Refitting
(
Removing
)
1. Use the hacksaw to cut the part, following the line shown in the figure to adjust to the required size.2. Remove the anti-corrosion treatment from the entire perimeter of the inside and outside of the replacement part using a rotary brush.- Apply electro-weldable paint to the edges involved.
1. Position the inner replacement part correctly on the vehicle and secure it using self-locking clamps.- Check the alignment and the surrounding gaps.2. Use a spot welder to weld the areas shown in the diagram.3. Use an MIG welder to seam-weld in the join areas.
- Correct any distortions to the panel using a mallet and dolly block.1. Use a disc grinder to level the welds.- Use a rotary brush to clean the previously welded areas.
1. Apply anti-oxidant protection to the areas involved in the welding.
1. Remove the anti-corrosion treatment from the entire perimeter of the inside and outside of the outer part using a rotary brush.- Apply electro-weldable paint to the edges involved.
1. Position the outer replacement part correctly on the vehicle and secure it using self-locking clamps.- Check the alignment and the surrounding gaps.2. Use a spot welder to weld the areas shown in the diagram.3. Use an MIG welder to seam-weld in the join areas.
- Correct any distortions to the panel using a mallet and dolly block.1. Use a disc grinder to level the welds.- Use a rotary brush to clean the previously welded areas.
1. Apply anti-oxidant protection to the areas involved in the welding.- Seal the join lines between the replacement part and the vehicle.
Removing
(
Refitting
)
Op. 7210E20 R.R. BONNET Op. 7210E36 R.R. FRONT SIDE DOOR Op. 7210E18 R.R. FRONT WING - Ensure that the components connected are not distorted by checking the body alignment measurements with suitable equipment (reference rigs, templates or gauges).- Straighten the body as necessary.
1. Grind the seam weld shown in the figure.- Use a rotary brush to remove the paint and gain access to the spot welds.2. Use the chamfering machine to remove the spot welds shown in the diagram.- Use a hammer and chisel to remove the previously chamfered spot welds.3. Remove the outer part of the component
