323003628 - 2127E42 HYDRAULIC SELECTION GEARBOX SHIFT POSITION SENSOR - R.R.

Removing ( Refitting )     Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R. 1. Disconnect the electrical connection for the gear engagement position sensor.
DescriptionConnector
1GEAR ENGAGEMENT POTENTIOMETER    See K069 GEAR ENGAGEMENT POTENTIOMETER
1. Undo the bolts (1a) and remove the gear engagement position sensor (1b) complete with O-ring.
Refitting ( Removing )
The gear engagement position sensor should be preloaded during the fitting stage and therefore proceed as described below.
1. Rotate the engagement pin in a clockwise direction until it is in the end of travel position.
1. Position the sensor complete with O-ring as illustrated in order to engage the pin positioned previously in line with the reference mark on the sensor.2. Rotate in a clockwise direction (preloading) until the openings are aligned and then press the sensor into place.
1. Tighten the bolts (1a) fixing the gear engagement position sensor (1b) to the recommended torque.
ComponentFasteningdia  Value (daNm)Validity
Gear engagement position sensorBolt-0.3 ÷ 0.421.3 Multijet MTA
- Connect the electrical connection for the gear engagement position sensor.    Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R. - If the sensor is being replaced, connect the Examiner and carry out the auto calibration procedure.