323000798 - K038 MILOMETER/TRIP METER FLASHING

TEST RESULTS
1CHECK USING DIAGNOSTIC EQUIPMENTALL OKPROBLEMS ENCOUNTEREDACTION
Connect an Examiner and check that the Instrument Panel Node is aligned in the "Control Units Test", "Other Systems" Group and "Proxy Alignment Procedure" modes.Move on to Step 21. Impossible to carry out Proxy alignment2. Alignment not carried out1. Move on to Step 22. Carry out Proxy alignment
2VEHICLE SPECIFICATION CHECKALL OKPROBLEMS ENCOUNTEREDACTION
Make sure that no control units not recognized by the Body Computer have been fitted in the CANMove on to Step 3A control unit not recognized by the Body Computer has been fitted in the CANRestore the system with the electronic devices for that specification.
3ELECTRICAL POWER SUPPLY CHECKALL OKPROBLEMS ENCOUNTEREDACTION
Check the electricity supply to the Instrument Panel Node is correct.    See E4010 INSTRUMENT PANEL Move on to Step 4Fault in positive electrical supply and/or earthRenew and/or replace the defective component (in the case of a fuse, find out what caused it to blow)
4ERROR CHECKALL OKPROBLEMS ENCOUNTEREDACTION
Check for the presence of one or more of the following errors using the Examiner in Instrument Panel Node mode:- CAN line- EEPROM memoryEnd of diagnosis1. Detected "no additional information" and/or "BUS off"2. Fault in EEPROM memory1. Continue as instructed by the diagnostic equipment2. Replace the Instrument Panel control unit.    Op. 5560B10 CONTROL PANEL - R+R