K144 ONE WARNING LIGHT ACTIVATED BY STEERING COLUMN SWITCH UNIT ON CONSTANTLY - Fiat - LINEA - eLearn

323000840 - K144 ONE WARNING LIGHT ACTIVATED BY STEERING COLUMN SWITCH UNIT ON CONSTANTLY

When the lights are deactivated using the steering wheel interface, the associated warning light on the instrument panel does not switch off

The warning lights activated when the steering wheel interface is operated are:- Side lights/number plate lights- Main beam headlamps- Direction indicators

0	PRELIMINARY CHECKS	All OK	Problems encountered	Operation
		Test results
	With the key to MAR, turn all the lights on and off from the steering wheel interface, i.e.:- using the wheel, side lights/number plate lights;- with the stalk, main beams (both fixed and flashing positions);- with the stalk, direction indicators (right and left) and check they turn on/off	Move on to Step 1	1. The side lights do not work2. The full beam headlamps do not work3. The direction indicators do not operate on both sides4. The direction indicators do not operate on one side	1. Continue as indicated See table I001 SIDE LIGHTS/NO. PLATE LIGHTS NOT WORKING 2. Continue as indicated See table I006 MAIN BEAM HEADLAMPS NOT WORKING 3. Continue as indicated See table I010 DIRECTION INDICATORS / HAZARD WARNING LIGHTS NOT WORKING 4. Continue as indicated See table I012 LEFT OR RIGHT DIRECTION INDICATORS NOT WORKING
1	CHECK USING DIAGNOSTIC EQUIPMENT	All OK	Problems encountered	Operation
	Using an Examiner in Instrument Panel Node mode, check that there are no errors and that the parameters are present	Move on to Step 2	Presence of errors	Continue following the instructions on the diagnostic instrument
2	ELECTRICAL POWER SUPPLY CHECK	All OK	Problems encountered	Operation
	Check the electrical power supply to the Instrument Panel Node is correct	Move on to Step 3	Fault in positive electrical supply and/or earth	Replace defective component (in the case of a fuse, find out what caused it to blow)
3	ELECTRICAL CONNECTIONS CHECK	All OK	Problems encountered	Operation
	Check the electrical connections between the Body Computer and the Instrument Panel. In particular, check that each individual pin is properly connected	Move on to Step 4	Electrical connections not operational	Renew the damaged electrical connections
4	ACTIVE DIAGNOSIS CHECK	All OK	Problems encountered	Operation
	Using an Examiner in Instrument Panel Node mode, check that the warning lights in question activate correctly in Active Diagnosis	Move on to Step 5	The warning lights do not flash	Replace the Instrument Panel Op. 5560B10 CONTROL PANEL - R+R
5	CHECK USING DIAGNOSTIC EQUIPMENT	All OK	Problems encountered	Operation
	Using an Examiner in Body Computer Node mode, check that there are no errors and that the warning light changes state	Move on to Step 6	1. Impossible to connect to the Body Computer control unit2. Presence of errors3. The parameters do not change	1. Move on to Step 62. Continue by following the instructions on the diagnostic instrument3. Move on to Step 7
6	ELECTRICAL POWER SUPPLY CHECK	All OK	Problems encountered	Operation
	Check the electrical power supply to the Body Computer Node is correct	Move on to Step 7	Fault in positive electrical supply and/or earth	Replace defective component (in the case of a fuse, find out what caused it to blow)
7	CHECK USING DIAGNOSTIC EQUIPMENT	All OK	Problems encountered	Operation
	Use an Examiner to check the possibility of connecting to the Body Computer Node	End of diagnosis	Impossible to connect to the Body Computer control unit	Replace Body Computer Op. 5505A35 MAIN BODY COMPUTER/JUNCTION UNIT - R.R.