4410B40 LOWER TRACK CONTROL ARM (WITH BALLJOINT) FOR LEFT OR RIGHT FRONT SUSPENSION (ONE) - R+R - CHECK WHEEL GEOMETRY SEPARATELY - Fiat - LINEA - eLearn

323001866 - 4410B40 LOWER TRACK CONTROL ARM (WITH BALLJOINT) FOR LEFT OR RIGHT FRONT SUSPENSION (ONE) - R+R - CHECK WHEEL GEOMETRY SEPARATELY

) Op. 4450B12 FRONT WHEELS (TWO) - R+R 1. Undo the bolt securing the left wishbone to the wheel strut.2. Unscrew the nut (2a) and use the tool (2b) to disconnect the steering link (2c) from the steering knuckle.

Tool	Description	Function	Validity
1871000700	Extractor	Extracting steering rod from strut

- Carry out this stage for the steering link on the right side as well.3. Undo the nut (3a) and disconnect the joint (3b) from the anti-roll bar.- Carry out this stage for the joint on the right side as well.

1. Undo the bolt (1a), the bolt (1b) securing the track control arm (1c) to the suspension crossmember and remove it.

Refitting ( Removing

) - Loosen the bolts securing the anti-roll bar to the suspension crossmember.- Move the steering knuckle assembly forwards and secure it appropriately.1. Place the track control arm (1a) in position and keep it horizontal using a column lift (1b).2. Tighten the new bolt (2a) and the new bolt (2b) securing the track control arm to the suspension crossmember to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Wishbone front bush to front suspension crossmember	Bolt (to be replaced)	M12	4.3 ÷ 4.7 + 90°

Component	Fastening	dia	Value (daNm)	Validity
Wishbone rear bush to front suspension crossmember	Bolt (to be replaced)	M12	4.3 ÷ 4.7 + 90°

- Remove the hydraulic lift.- Tighten the bolts securing the anti-roll bar loosened previously to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Anti-roll bar to front suspension crossmember	Nut	M8	2.3 ÷ 2.7

- Connect the joint to the anti-roll bar and tighten the securing nut to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Anti-roll bar joint	Nut	M10	4.5 ÷ 5.5

- Connect the steering link to the steering knuckle, left and right sides and tighten the securing nut to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Steering rod to pillar	Nut	M10	3.6 ÷ 4.4

- Connect the track control arm to the steering knuckle and tighten the bolt to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Front suspension lower wishbone - strut side	Bolt (to be replaced)	M10	3.8 ÷ 4.2 + 45°

Op. 4450B12 FRONT WHEELS (TWO) - R+R