5580C44 FRONT SIDE BAG MODULE (ONE) LH OR RH - R.R - Fiat - LINEA - eLearn

323002127 - 5580C44 FRONT SIDE BAG MODULE (ONE) LH OR RH - R.R

)

Before removing and refitting the Air Bag module the following preliminary operations must be carried out.- Turn the ignition key to the OFF position and extract it.- Disconnect the battery leads and insulate them.- Wait for 10 minutes before continuing.

FOLLOW ALL THE RECOMMENDED SAFETY INSTRUCTIONS Op. 5580C AIR BAG SYSTEM

Op. 7045A10 FRONT SEAT (ONE), LEFT OR RIGHT - R.R. Op. 7045A44 FRONT SEAT INTERIOR GUARD (ONE), LEFT OR RIGHT - R.R Op. 7045A24 FRONT SEAT BACKREST ANGLE ADJUSTMENT KNOB (ONE), LEFT OR RIGHT - R.R. Op. 7045A56 DRIVER'S SEAT HEIGHT ADJUSTMENT DEVICE CONTROL LEVER - R.R Op. 7045A43 FRONT SEAT EXTERIOR GUARD (ONE), LEFT OR RIGHT - R.R 1. Open the zip fastener (1a) along the entire section (1b).2. Disconnect the lower two ends of the backrest trim attached to one another.3. Lift the backrest cover upwards, until the Air Bag module can be accessed.

1. Undo the nuts fixing the Air Bag module.2. Disconnect the earth lead from the threaded pin.

1. Move the Air Bag module.2. Detach the electrical connection.

	Description	Connector
2	DRIVER''S SIDE BAG	See Q030 DRIVER'S SIDE BAG
2	PASSENGER SIDE BAG	See Q031 PASSENGER SIDE BAG

3. Keep the Air Bag module.

Place the Air Bag module in the special cupboard resting it on a free surface with the bag facing upwards.

Refitting ( Removing

) - Observe the following precaution.

Handle the Air Bag module very carefully. Make sure that the battery is disconnected.

- If a new module is being fitted, position the labels as described below.- Remove the detachable part of the adhesive label from the new module. Place a copy of the label in a special folder containing the vehicle details (model, registration date, chassis number) and the serial number of the old module. The file should be kept for future checks.- Fit the detachable part of the original label on the lower part of the seat, where similar labels for the seat, the backrest cover and the Air Bag wiring can already be found. Beforehand, however, it should be perforated at the month and 14 years after the year in which the module is being fitted (e.g. 2005 for 2019).- Position the Air Bag module and connect the electrical connection.- Place the Air Bag module in its housing.- Connect the earth lead to the threaded pin.- Tighten the nuts fixing the Air Bag module.

Component	Fastening	dia	Value (daNm)	Validity
Side Air Bag module	Nut	-	0.7 ÷ 0.9

- Position the padding on the seat frame and fit the backrest cover on the padding.- Connect the lower two ends of the backrest cover attaching them to one another.- Close the zip fastening along the entire length. Op. 7045A43 FRONT SEAT EXTERIOR GUARD (ONE), LEFT OR RIGHT - R.R Op. 7045A56 DRIVER'S SEAT HEIGHT ADJUSTMENT DEVICE CONTROL LEVER - R.R Op. 7045A24 FRONT SEAT BACKREST ANGLE ADJUSTMENT KNOB (ONE), LEFT OR RIGHT - R.R. Op. 7045A44 FRONT SEAT INTERIOR GUARD (ONE), LEFT OR RIGHT - R.R Op. 7045A10 FRONT SEAT (ONE), LEFT OR RIGHT - R.R. - After having refitted the seat, connect the battery and check, using the Examiner, that the system has not acquired any errors during operation.