5530A10 ALTERNATOR - R+R - Fiat - LINEA - eLearn

323000050 - 5530A10 ALTERNATOR - R+R

)

Follow the safety instructions Op. 5040 AIR CONDITIONING CASING AND COMPONENTS

- Position the vehicle on a lift.- Drain the coolant. Op. 0010T84 COOLANT FOR AIR CONDITIONING SYSTEM - DEHYDRATE AND REPRESSURIZE Op. 4450B04 RIGHT FRONT WHEEL - R.R Op. 7055B66 ENGINE COMPARTMENT DUST COVER IN RIGHT FRONT WHEEL ARCH - R.R. Op. 1092C10 POWER STEERING AND/OR SELF-LEVELLING SUSPENSION PUMP DRIVE BELT - R + R Op. 1092B40 AIR CONDITIONING COMPRESSOR/ALTERNATOR DRIVE BELT - R + R 1. Undo bolt (1a) and disconnect connector (1b) for the pipe from compressor (1c).(Operation required in order to unscrew the upper alternator bolt (2a)).

Seal the connectors that have been disconnected using suitable plugs to prevent dampness and impurities from entering the system.

2. Unscrew the upper bolt (2a) for the alternator (2b).

- Raise the vehicle.1. Release and open the cover for the alternator electrical connections.2. Undo the nuts and disconnect the electrical connections (2a) and (2b) for the alternator.

	Description	Connector
2	ALTERNATOR	See A010 ALTERNATOR

3. Loosen the lower alternator retaining bolts.4. Remove the alternator.

Refitting ( Removing

) - Check that the alternator is not damaged.1. Position the alternator.2. Screw in the lower alternator retaining bolts and tighten them to the specified torque.

Component	Fastening	dia	Value (daNm)	Validity
Alternator to mounting	Bolt	M10x1.25	4.5 ÷ 5.5	1.4 16v TJET

Component	Fastening	dia	Value (daNm)	Validity
Alternator to mounting	Nut	M10x1.25	4.5 ÷ 5.5	1.4 16v TJET

3. Connect the electrical connections (3a) and (3b) for the alternator and secure them using the nuts (3c).

Component	Fastening	dia	Value (daNm)	Validity
Alternator recharging lead	Nut	M8	0.7 ÷ 1.1

Component	Fastening	dia	Value (daNm)	Validity
Warning light supply lead at alternator	Nut	M5	0.3 ÷ 0.5

4. Close the cover for the electrical connections.

- Lower the vehicle.1. Screw in the upper alternator bolt and tighten to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Alternator to mounting	Bolt	M10x1.25	4.5 ÷ 5.5	1.4 16v TJET

Replace the O-rings on the connectors. Only use green coloured seals that are resistant to R134a coolant.Lubricate the connector threads using anti-freeze.

2. Connect connector (2b) for the pipe to compressor (2a) and secure it by tightening bolt (2c).

Op. 1092B40 AIR CONDITIONING COMPRESSOR/ALTERNATOR DRIVE BELT - R + R Op. 1092C10 POWER STEERING AND/OR SELF-LEVELLING SUSPENSION PUMP DRIVE BELT - R + R Op. 7055B66 ENGINE COMPARTMENT DUST COVER IN RIGHT FRONT WHEEL ARCH - R.R. Op. 4450B04 RIGHT FRONT WHEEL - R.R - Repressurize the coolant Op. 0010T84 COOLANT FOR AIR CONDITIONING SYSTEM - DEHYDRATE AND REPRESSURIZE - Remove the vehicle from the lift.