323001940 - 44B ROAD TEST FOR ROLLING/PITCHING EVALUATION

- Carry out a road test on traffic-free roads in safe conditions, following the highway code.- Before proceeding with the test, check the inflation pressure of the two vehicles, restoring the values to the correct ones if they are found to be incorrect.- Also check the condition of the wheel rims, making sure they are not distorted or broken, and replacing them if any faults are found.- Carry out the test on a route where there are left and right hand bends of different degrees, evaluating the dipping speed of the vehicle round the bends, trying to take the bends at a constant speed, avoiding carrying out pull/release manoeuvres.- Evaluate the stability of the vehicle by simulating a lane change/overtake and check that violent vehicle reactions do not occur, leading to unsafe driving during this manoeuvre.- Then carry out a road test on an uneven road (transverse rails, cobblestones, paving stones) with right/left hand bends of different degrees to evaluate the tendency of the rear of the vehicle to lose grip.- This type of test should always be used for comparison with a new vehicle or reference vehicle of the same trim level and engine type, available in the workshop at the time of the test in question.- At the end of the test in question, assess/rate the performance of the vehicle in terms of rolling/pitching in accordance with the attached table.
JudgementScore
Poor3
Mediocre4
Just acceptable5,5
Acceptable6
Good7
The reference vehicle has a rolling/pitching default rating of 7.