108807 - 2125C22 GEAR control LEVER and SUPPORT - R.R.

Refitting

    See in Op. 1076B70 EXHAUST PIPE BETWEEN PRECATALYZER AND CATALYZER - R.R.-    See in Op. 1080B62 CATALYTIC CONVERTER - R.R.- - Raise the lift.1. Undo the retaining nuts.2. Remove the side flexible mounting supporting the exhaust pipe.3. Remove the front heat shield (3a) and the centre one (3b) for the exhaust pipe.

1. Undo the nut fixing the front bracket for the flexible cables to the bodyshell.2. Remove the protective cover working on the fastening springs.3. Release the ends (3a) of the selector and engagement cables from the lever and from the idler by pressing the tabs (3b).4. Remove the fastening springs and release the two flexible cables from the mounting.5. Undo the fixing nuts (5a) and remove the gear lever support (5b).

Refitting ( Removing ) - Position the gear lever support complete with idler.- Tighten the bolts fixing the support to the bodyshell to torque.

	Value - daNm	Fastening	Component	Ø
.	1.7	Bolt	MANUAL GEARBOX LEVER SUPPORT (F)	M8

- Fit the ends of the selector and engagement cables on the lever and on the idler.- Fit the fastening springs for the two flexible cables on the support.- Fit the protective cover in the housing on the support.- Tighten the nut fixing the mounting bracket for the flexible cables to the bodyshell.- Fit the front heat shield and tighten the fixing nuts.     See in Op. 1080B62 CATALYTIC CONVERTER - R.R.-    See in Op. 1076B70 EXHAUST PIPE BETWEEN PRECATALYZER AND CATALYZER - R.R.-     See in Op. 2125C26 Lever/grip TRIM - R.R. for versions with reverse gear engagement device- Remove the vehicle from the lift.