177973 - 4420C80 Rear suspension CAMBER ROD - R.R.

Removing ( Refitting ) - Position the vehicle on a lift.    See in Op. 4450B13 Rear WHEELS (two) - R.R.    See in Op. 7055B45 Right rear wheel arch liner - R.R.    See in Op. 1076B20 Rear exhaust SILENCER - R.R.    See in Op. 4420D10 REAR SUSPENSION AXLE - R.R.    See in Op. 4420C82 Rear suspension CAMBER ROD - R.R. WITH SUSPENSION CROSSMEMBER REMOVED Refitting ( Removing )     See in Op. 4420C82 Rear suspension CAMBER ROD - R.R. WITH SUSPENSION CROSSMEMBER REMOVED    See in Op. 4420D10 REAR SUSPENSION AXLE - R.R.    See in Op. 1076B20 Rear exhaust SILENCER - R.R.    See in Op. 7055B45 Right rear wheel arch liner - R.R.    See in Op. 4450B13 Rear WHEELS (two) - R.R.- Place the vehicle in Standard "A" conditions, in other words with the vehicle mass complete, spare wheel, tool kit, all supplies and accessories (oil, engine coolant, etc.) and a full fuel tank.- Check that the tyre inflation pressure is correct.- Position the vehicle on a support so that the wheels are resting on the ground. - Check that after the vehicle has been placed in standard "A" conditions, the measurement "D"-"C" corresponds to the figure given in the table below.
SubjectValue
.Rear wheel geometrymm
-D - C21 ± 5
-Standard A-
- Check that after the vehicle has been placed in standard "A" conditions, the measurement "D"-"C" corresponds to the figure given in the table below.
SubjectValue
.Rear wheel geometrymm
-D - C21 ± 5
-Standard A-
- Tighten the bolts fixing the rod to the steering knuckle to torque.
Value - daNmFasteningComponentØ  
.(Steering knuckle) 11BoltHOUSING LINKM12X1.25
- Tighten the bolts fixing the camber rod to the rear axle to torque.
Value - daNmFasteningComponentØ  
.(Crossmember side) 9NutHOUSING LINKM12X1.25
    See in Op. 4450A40 REAR WHEEL GEOMETRY - Check using optical equipment - Includes rear wheel toe-in adjustment if necessary