78957 - 4450A10 FRONT WHEEL GEOMETRY - Check using optical equipment - Includes front wheel toe-in adjustment if necessary

- Position the vehicle on a test bench, with sliding plates on all the wheels.- Place the vehicle in standard "A" conditions (with spare wheel, tool kit, all supplies and a full fuel tank).- Check that the tyre inflation pressure is correct.- GEOMETRY CHECK 1. Check that the front wheel geometry (B-A) is correct.
SubjectValue
.Front wheel geometrymm
-A - B163 ± 5
-Standard A-
- CAMBER CHECK 1. Check that the front wheel camber is correct.
The front wheel camber cannot be adjusted. If the figure does not correspond to the vales given, check the suspension track control arm and the bodyshell.
SubjectValue
.Front wheel camber-
---50' ± 20'
-Standard A-
- TOE IN CHECK 1. Check that the front wheel toe in (D2-D1) correponds to the recommended figures
SubjectValue
.Front wheel toe inmm
-D2 - D1-2 ± 1
-Standard A-
- If the front wheel toe in value is not within the recommended figures, adjust it following the instructions given below.- Make sure that the steering wheel is perfectly straight and lock it in this position using a suitable tool.- Loosen the bands securing the power assisted steering box boots to the steering rods.1. Loosen the steering rod nuts.2. Tighten or loosen the steering rods until the toe in is correct keeping the front wheels aligned.
- Tighten the steering rod nuts to the recommended torque.
Value - daNmFasteningComponentØ  
.(Power assisted steering box side) 5NutSTEERING RODS ADJUSTABLE WITH BOXES (C.S.)M14
- Tighten the bands securing the power assisted steering box boots to the steering rods.- Remove the flywheel lock.