95880 - 1088D36 CONNECTOR ON CRANKCASE FOR CYLINDER HEAD/CRANKCASE WATER CIRCUIT HOSE WITH THERMOSTAT CLOSED - R.R.

Refitting

    See in Op. 7055B54 PROTECTION/GUARD under engine - R.R.    See in Op. 1080D24 engine oil vapour intake pipe - r + r    See in Op. 1016A40 Ignition COIL COVER on cylinder head - R.R.    See in Op. 1048A50 air inlet pipe to turbocharger - r + r    See in Op. 1084A16 Engine oil dip stick PIPE - R.R.    See in Op. 1072B10 INTAKE MANIFOLD - R.R. and Replace gasket 1. Undo the bolts (1a), disconnec the band (1b) on the hose (1c) and remove the connector on the crankcase for the cylinder head/crankcase water circuit with the thermostat closed (1d).2. Remove the O-ring.

Collect the coolant that comes out in a suitable container.

Refitting ( Removing ) - Position the connector on the crankcase for the cylinder head/crankcase water circuit with the closed thermostat, complete with O-ring, in its housing, then secure it using the bolts.     See in Op. 1072B10 INTAKE MANIFOLD - R.R. and Replace gasket    See in Op. 1084A16 Engine oil dip stick PIPE - R.R.    See in Op. 1048A50 air inlet pipe to turbocharger - r + r    See in Op. 1016A40 Ignition COIL COVER on cylinder head - R.R.    See in Op. 1080D24 engine oil vapour intake pipe - r + r    See in Op. 7055B54 PROTECTION/GUARD under engine - R.R.     See in Op. 7040D50 ENGINE COMPARTMENT UPPER SOUND INSULATION SHIELD - R.R.- Connect the negative battery terminal, then close the boot.- Remove the vehicle from the lift.