155805 - 3330C10 MASTER CYLINDER (PUMP) - R.R. - Bleed air from brakes separately

Removing ( Refitting ) - Position the vehicle on a lift.    See in Op. 7040D50 ENGINE COMPARTMENT UPPER SOUND INSULATION SHIELD - R.R.     See in Op. 1048A50 air inlet pipe to turbocharger - r + r-    See in Op. 1048A21 AIR INLET HOSE FROM INTAKE TO FILTER - R.R.     See in Op. 3340A12 A.B.S. hydraulic and electronic CONTROL UNIT - R.R. - Includes bleeding air1. Undo the connectors for the rigid pipes on the brake pump.2. Remove the two rigid pipes connected to the hydraulic and electronic control units.3. Undo the fixing nuts (3a) and remove the brake pump (3b).
When refitting the pump to the brake servo do NOT carry out any adjustment operation.
Refitting ( Removing ) - Fit the rigid pipe connecting the brake pump and the A.B.S. electro-hydraulic control unit.- Tighten the connector on the brake pump to torque.
Value - daNmFasteningComponentØ  
.1.4ConnectorFRONT BRAKE RIGID PIPE FROM MASTER CYLINDERM12
    See in Op. 3340A12 A.B.S. hydraulic and electronic CONTROL UNIT - R.R. - Includes bleeding air-     See in Op. 1048A21 AIR INLET HOSE FROM INTAKE TO FILTER - R.R.    See in Op. 1048A50 air inlet pipe to turbocharger - r + r-     See in Op. 0010T64 Brake and/or clutch fluid - Check level and top up, if necessary-    See in Op. 0010T65 HYDRAULIC BRAKING SYSTEM - BLEED AIR-    See in Op. 7040D50 ENGINE COMPARTMENT UPPER SOUND INSULATION SHIELD - R.R.- Remove the vehicle from the lift.