75097 - 1072C44 Exhaust manifold heat shield on BULKHEAD - R.R.

Removing ( Refitting ) - Position the vehicle on a lift.- Make sure that the ignition key is in the OFF position, then open the boot, remove the cover on the left hand side and disconnect the negative battery lead.- Raise the vehicle on the lift.    See in Op. 7040D50 ENGINE COMPARTMENT UPPER SOUND INSULATION SHIELD - R.R.    See in Op. 1088E10 Radiator cooling FAN - R.R.    See in Op. 1048A10 COMPLETE AIR FILTER -R.R.    See in Op. 1048A50 air inlet pipe to turbocharger - r + r    See in Op. 1048A21 AIR INLET HOSE FROM INTAKE TO FILTER - R.R.    See in Op. 1016A40 Ignition COIL COVER on cylinder head - R.R.1. Disconnect the electrical connection for the rear Lambda sensor.
DescriptionConnector
1 Lambda sensor on catalyzerK017
1. Undo the fixing nuts (1a) and the bolt (1b) and extract the heat shield (1c) upwards.
Refitting ( Removing ) - Position the heat shield bulkhead.- Tighten the bolt and the nuts fixing the heat shield bulkhead.- Connect the electrical connection for the front Lambda sensor.
DescriptionConnector
.Lambda sensor on catalyzerK017
    See in Op. 1016A40 Ignition COIL COVER on cylinder head - R.R.    See in Op. 1048A21 AIR INLET HOSE FROM INTAKE TO FILTER - R.R.    See in Op. 1048A50 air inlet pipe to turbocharger - r + r    See in Op. 1048A10 COMPLETE AIR FILTER -R.R.    See in Op. 1088E10 Radiator cooling FAN - R.R.    See in Op. 7040D50 ENGINE COMPARTMENT UPPER SOUND INSULATION SHIELD - R.R.- Connect the negative battery terminal, then close the boot.- Remove the vehicle from the lift.