76280 - 1092G10 Engine components single drive BELT - R.R.

Refitting

    See in Op. 7055B54 PROTECTION/GUARD under engine - R.R.    See in Op. 4450B04 Right FRONT WHEEL (one) - R.R.    See in Op. 7055B42 FRONT WHEEL ARCH LINER (one), left or right - R.R.    See in Op. 7055B64 Engine compartment DUST SEAL in front wheel arch (one), left or right - R.R.1. Undo the bolt fixing the reaction rod to the bodyshell.

- Position a hydraulic lift under the gearbox to support the power unit.1. Undo the bolts fixing the engine support to the gearbox.- Gently lower the hydraulic lift until it is resting on the crossmember.

1. Adjust the moving tensioner (1a) for the single drive belt using the spanner (1b), then insert the tool (1c) in the opening in the tensioner.

	Description	Code	Function
1b	Spanner	1.860.966.000	-

	Description	Code	Function
1c	Lock	1.870.645.000	Tensioning auxiliary shaft belt

2. Remove the protective plug for the auxiliar shaft drive belt cam tensioner.3. Undo the bolt retaining the cam tensioner.4. Remove the auxiliary shaft drive belt.

Refitting ( Removing ) - Fit the single drive belt on the pullies.

Avoid the belt coming into contact with oil or solvents that could alter the flexibility of the rubber with a resulting loss of adhesion. Also check that the belt shows no signs of cracks or cuts or else it will have to be played.

1. Rotate the cam tensioner (1a) using the tool (1b) until the clip (1c) can be released easily, then lock the bolt (1d) fixing the cam tensioner.

	Description	Code	Function
1b	Spanner	1.860.968.000	Tensioning auxiliary shaft belt

	Description	Code	Function
1c	Lock	1.870.645.000	Tensioning auxiliary shaft belt

	Value - daNm	Fastening	Component	Ø
.	5	Bolt	SINGLE BELT MOVING TENSIONER VARIOUS	M10

- The device is tensioned automatically and by means of a pre-loaded spring imparting the correct tension on the belt during fitting and the automatic recovery of the clearance produced during normal operation.- Fit the plug in the cam tensioner.- Raise the power unit with the hydraulic device under the gearbox.- Tighten the bolts fixing the engine support, gearbox side.

	Value - daNm	Fastening	Component	Ø
.	(Gearbox side) 5	Bolts	POWER UNIT GEAR BOX END RIGID MOUNT	M10

- Tighten the bolt fixing the reaction rod to torque.

	Value - daNm	Fastening	Component	Ø
.	(body) 5	Bolt	POWER UNIT REACTION ROD	M10

- Remove the hydraulic lift.    See in Op. 4450B04 Right FRONT WHEEL (one) - R.R.    See in Op. 7055B42 FRONT WHEEL ARCH LINER (one), left or right - R.R.    See in Op. 7055B64 Engine compartment DUST SEAL in front wheel arch (one), left or right - R.R.    See in Op. 7055B54 PROTECTION/GUARD under engine - R.R.    See in Op. 7040D50 ENGINE COMPARTMENT UPPER SOUND INSULATION SHIELD - R.R.- Connect the battery terminal.