109018 - 7005A42 Front side door SEAL, left or right - R.R.
Removing ( Refitting ) - Disconnect the negative battery terminal. See in Op. 7005E18 Front side door armrest - R.R. See in Op. 7005E08 Front side door INTERIOR PANEL - R.R. See in Op. 7005E42 Front side door frame MOUDLING - R.R.1. Release the rubber protection (1a), undo the bolts (1b) and detach the door check strap (1c), door pillar side.
1. Release and remove the seal following the procedure described below.- Use a bodywork drier which produces hot air at between 35 and 40°C.- Point the air towards one of the two ends for 10-15 seconds from a distance of around 20-30 cm.- Remove about 5-10 cm of the end avoiding rapid movements or angles that could cause breakages.- Lift up the end removed previously and point the hot air between the adhesive and the paintwork from around 20-30 cm away for 15-20 seconds, then start pulling the seal towards you continuing to heat it using the drier to facilitate its removal and reduce the presence of any residues of adhesive or foam.
Refitting
(
Removing
)
- Clean the door surround using paper soaked in heptane starting from the top centre line of the door working downwards in a clockwise direction and from the top centre line working downwards in an anti-clockwise direction until the door surround is completed.
Do not use the seal that has been removed from the door. |