109134 - 7005E08 Front side door INTERIOR PANEL - R.R.

Removing ( Refitting ) - Disconnect the negative battery terminal.    See in Op. 7005E18 Front side door armrest - R.R.1. Release the side door grab handle trim and remove it.
1. Undo the fixing bolts.2. Lift up the door opening handle (2a), release the cap (2b) and undo the bolt underneath (2c).3. Release the front door panel (3b) using the tool (3a).
DescriptionCodeFunction
3a Knife1.878.077.000Removing rear side door inner panel
4. Release the front door opening cable.
1. Working on the inside of the panel, disconnect the electrical connectors (1a), (1b), (1c).
DescriptionConnector
1a Driver's door control unit (NPG)M066A
DescriptionConnector
1b Left front door light (courtesy)G051
DescriptionConnector
1b Right front door light (courtesy)G052
DescriptionConnector
1c Left front door handle lightG065
DescriptionConnector
1c Right front door handle lightG066
DescriptionConnector
1a Driver's door control unit (NPG)M066B
DescriptionConnector
1a Driver's door control unit (NPG)M066C
1. Undo the fixing bolts (1a) and remov ethe side door locking/unlocking switch (1b).
1. Undo the fixing bolts (1a) and remove the passive entry aerial (1b).
1. Undo the bolts (1a) and remove the front door locking/unlocking signal unit (1b).
- Remove the door panel. Refitting ( Removing ) - Position the front door locking/unlocking signal unit and secure it using the bolts.- Position the passive entry aerial and secure it using the bolts.- Position the side door locking/unlocking switch and secure it using the bolts.1. Working on the inside of the panel, connect the electrical connectors (1a), (1b), (1c).
DescriptionConnector
1a Driver's door control unit (NPG)M066A
DescriptionConnector
1b Left front door light (courtesy)G051
DescriptionConnector
1b Right front door light (courtesy)G052
DescriptionConnector
1c Left front door handle lightG065
DescriptionConnector
1c Right front door handle lightG066
DescriptionConnector
1a Driver's door control unit (NPG)M066B
DescriptionConnector
1a Driver's door control unit (NPG)M066C
- Check that the components involved are working properly.- Reposition the front door opening cable.- Fit the inner door panel in the housing until the click of the retaining springs can be heard.- Tighten the bolts fixing the door panel.- Reposition the side door inner grip trim.    See in Op. 7005E18 Front side door armrest - R.R.- Connect the negative battery terminal.