606282 - 0010T12 ENGINE OIL AND FILTER - REPLACE

The oil should be changed with the engine hot to facilitate the drainage of the used oil.

- Position a suitable container under the vehicle by the drain plug. 1. Undo the drain plug in the crankcase sump and leave the oil to drain into the container.

Be very careful when removing the drain plug; the oil could be very hot.

Do not let the oil disperse into the atmosphere as this could cause pollution.

- Proceed with removing the engine oil filter following the specific instructions for each engine type:    See in Op. 1084B30 CARTRIDGE ENGINE OIL FILTER -R.R. - Refill the lubrication circuit with the recommended oil.

	Description	Qty.	Component	Type	Classification
.	SELENIA TURBODIESEL	5.50 Litri	ENGINE LUBRICATION SYSTEM	Oil	SAE10W40-ACEA B3-API CD

Never exceed the MAX level

- The following fluid is recommended for temperatures down to - 15°.

	Description	Qty.	Component	Type	Classification
.	SELENIA WR DIESEL	5.50 Litri	ENGINE LUBRICATION SYSTEM	Oil	SAE 5W40-ACEA B4-API CF

    See in Op. 0010T11 ENGINE OIL - Check level and top up if necessary- Check that the oil level is correct using the dipstick with reference to op- Fit the filler cap.- Start the engine and let it idle for about two minutes; switch off the engine and wait for a few minutes.- Check that the oil level is correct once again.    See in Op. 7055B54 PROTECTION/GUARD under engine - R.R.- Remove the vehicle from the lift.