0010T12 ENGINE OIL AND FILTER - REPLACE - Lancia - THESIS - eLearn

606282 - 0010T12 ENGINE OIL AND FILTER - REPLACE

- Position the vehicle on the lift.

The oil should be changed with the engine hot to facilitate the drainage of the used oil.

- Remove the filler cap- Release the dipstick.- Raise the vehicle. See in Op. 7055B54 PROTECTION/GUARD under engine - R.R.- Position a suitable container under the vehicle by the drain plug. - Proceed with removing the engine oil filter following the specific instructions for each engine type: See in Op. 1084B30 CARTRIDGE ENGINE OIL FILTER -R.R.

	Description	Qty.	Component	Type	Classification
.	SELENIA TURBODIESEL	5 Litri	ENGINE LUBRICATION SYSTEM	Oil	SAE 10W40-ACEA B3-API CD

Never exceed the MAX level

- The following fluid is recommended for temperatures down to - 15°.

	Description	Qty.	Component	Type	Classification
.	SELENIA WR DIESEL	5 Litri	ENGINE LUBRICATION SYSTEM	Oil	SAE 5W40-ACEA B4-API CF

- If the lubrication system is completely drained (engine, filter and oil heat exchanger), the amount of fluid to be introduced into the circuit is 6 litres. See in Op. 0010T11 ENGINE OIL - Check level and top up if necessary- Check that the oil level is correct using the dipstick with reference to op- Fit the filler cap.- Start the engine and let it idle for about two minutes; switch off the engine and wait for a few minutes.- Check that the oil level is correct once again. See in Op. 7055B54 PROTECTION/GUARD under engine - R.R.- Remove the vehicle from the lift.