1008B30 GEARBOX SIDE MOUNT FLEXIBLE BLOCK/S - REPLACE - Lancia - THESIS - eLearn

849877 - 1008B30 Gearbox side mount FLEXIBLE BLOCK/S - Replace

) - Position the vehicle on a lift. See in Op. 7040D50 ENGINE COMPARTMENT UPPER SOUND INSULATION SHIELD - R.R. See in Op. 1016A10 SOUND-PROOFING COVER - R.R. See in Op. 7055B54 PROTECTION/GUARD under engine - R.R. See in Op. 1048B44 RIGID air supply PIPE from heat exchanger to intake manifold - R.R. See in Op. 1048A56 UPPER RESONATOR - R.R. See in Op. 1048A50 air inlet pipe to turbocharger - r + r- Lower the lift.1. Undo the bolt fixing the reaction rod to the bodyshell.

1. Remove the safety seal applied to the electrical connector, then disconnect the brakesystem control unit electrical connector (NFR).

	Description	Connector
1	Braking system control unit (NFR)	M051

2. Undo the nuts securing the brake system control unit (NFR) to the bracket.

- Position the hydraulic engine support under the oil sump in order to work safely.1. Undo the nuts fixing the flexible block to the mount.2. Undo the pin connecting the rigid support to the flexible mounting.- Gently lower the hydraulic lift until the gearbox bell housing is resting on the crossmember.3. Remove the gearbox side flexible mounting.

Refitting ( Removing

) 1. Fit the flexible block in the itshousing and tighten the nuts.- Tighten the threaded pin joined to the block.2. Tighten the pin connecting the rigid support to the flexible mounting to torque.

	Value - daNm	Fastening	Component	Ø
2	(Mounting side) 5.8	Threaded pin	POWER UNIT GEAR BOX END RIGID MOUNT	M10X1.25

3. Tighten the nuts securing the flexible block to the mount to torque.

	Value - daNm	Fastening	Component	Ø
3	(Mount) 5.8	Nuts	GEARBOX SIDE RUBBER MOUNT	M10X1.25

- Remove the hydraulic safety device positioned under the oil sump.- Tighten the nuts securing the brake system control unit (NFR) to the bracket.

	Value - daNm	Fastening	Component	Ø
.	1.5	Nuts	HYDRAULIC AND ELECTRONIC CONTROL UNIT	M8

- Connect the electrical connection for the brake system electronic control unit (NFR).

	Description	Connector
.	Braking system control unit (NFR)	M051

- Tighten the reaction rod bolt to torque.

	Value - daNm	Fastening	Component	Ø
.	(body) 5	Bolt	POWER UNIT REACTION ROD	M10

See in Op. 1048A50 air inlet pipe to turbocharger - r + r See in Op. 1048A56 UPPER RESONATOR - R.R. See in Op. 1048B44 RIGID air supply PIPE from heat exchanger to intake manifold - R.R. See in Op. 7055B54 PROTECTION/GUARD under engine - R.R. See in Op. 1016A10 SOUND-PROOFING COVER - R.R. See in Op. 7040D50 ENGINE COMPARTMENT UPPER SOUND INSULATION SHIELD - R.R.- Remove the vehicle from the lift.