177587 - 4410A80 Lower fork connecting front suspension SHOCK ABSORBER to LOWER TRACK CONTROL ARM (one), left or right - R.R.

Refitting

1. Undo the fixing bolts.2. Undo the fixing nut (2a) and disconnect the end of the anti-roll bar (2b).3. Undo the fixing nut (3a) and move the accelerator sensor (3b) aside.

1. Undo the fixing bolts.2. Separate the two heads from the suspension housing.3. Remove the suspension fork.

Take great care not to damage the brake fluid pipes and the electrical leads for the sensors, if necessary, release them from the bands on the steering knuckles.

Refitting ( Removing ) - Fit the suspension fork on the shock absorber.- Place the steering knuckle in its original position checking that the driveshafts are engaged in the housing on the differential and on the intermediate driveshaft.- Secure the two ends in the special housings in the suspension and tighten the fixing bolts to torque.

	Value - daNm	Fastening	Component	Ø
.	3.4	Bolt	FRONT SHOCK ABSORBERS (S.M.)	M8

- Tighten the bolt fixing the fork to the track control arm.

	Value - daNm	Fastening	Component	Ø
.	9	Bolt	FRONT DAMPER FORK ON WISHBONE	M12

- Tighten the bolts fixing the fork to the shock absorber to torque.

	Value - daNm	Fastening	Component	Ø
.	11.6	Bolt	FRONT DAMPER FORK ON WISHBONE	M12 X 1.25

- Tighten the nuts fixing the left and right track rod ends for the anti-roll bar.

	Value - daNm	Fastening	Component	Ø
.	5.5	Nut	FRONT ANTI-ROLL BAR JOINTS	M10 X 1.25

- Fit the left and right acceleration sensors in the housing on the fork and secure them using the nuts.    See in Op. 4450B04 Right FRONT WHEEL (one) - R.R.- Remove the vehicle from the lift.