501025 - 7210A55 PILLAR PANEL BRACKET/REINFORCEMENT

The vehicle should be in the following condition before the operation: front wing detached, bonnet removed
Removing ( Refitting ) - Check whether the components connected are distorted through the bodyshell alignment measurements using suitable test equipment (test benches, templates or jigs).- Carry out any bodyshell straightening operations before cutting the component.1. Using a chamfering machine and a drill, remove the spot welds along the perimeter of the bracket.2. Cut along the line illustrated in the areas in contact with the front pillar using a power saw.
- Straighten the edges of the panel along the surface of the bodyshell involved.1. Remove the anti-corrosion treatment using a rotary brush from the entire inner (1a) and outer (1b) perimeter of the replacement part.2. Apply electro-galvanizing paint to the inner perimeter of the replacement part.
1. Clean the perimeter of the bodyshell involved thoroughly using a rotary brush and apply electro-galvanizing paint.
- Position the replacement part correctly, secure it using self-locking clamps and check that it is correctly positioned.1. Use a spot welder in the areas shown in the diagram.2. Weld in the area shown in the diagram.
- Clean the areas involved in the welding thoroughly removing the excess material.- Check that the component fitted is correctly positioned.- Apply electro-galvanizing paint to the parts ground.
When the operation is completed, refit the elements removed previously.