1036C14 CAMSHAFTS IN CYLINDER HEAD - R.R. WITH HEAD REMOVED - Lancia - THESIS - eLearn

850215 - 1036C14 CAMSHAFTS in cylinder head - R.R. with head removed

) 1. Position the camshaft housing (1a) in a vice using the tool (1b).

	Description	Code	Function
1b	Support	1.860.470.001	Service cylinder head

1. Undo the bolt (1a) and remove the cam angle sensor (1b).

- Check that the camshaft endfloat is within the recommended values using a dial gauge.

	Subject	Value
.	Camshaft	mm
-	End float	-

- If the camshaft endfloat is not within the recommended values, replace the worn components when reassembling the cylinder head.1. Remove the plugs (1a) and fit the camshaft timing tools (1b) on the camshaft housing.

Check that the tools are correctly fitted with the letters "A" and "S" in the housings in the inlet and exhaust camshafts.

	Description	Code	Function
1b	Templates	1.870.896.900	Engine tuning

1. Undo the bolts fixing the camshaft gears.

- Remove the camshaft timing tools from the camshaft housing.

	Description	Code	Function
.	Templates	1.870.896.900	Engine tuning

1. Release the camshafts (1a), as necessary and remove the camshaft gears (1b).

1. Extract the inlet side camshaft (1a) and plug (1b) using a suitable drift.2. Extract the exhaust side camshaft (2a) and oil seal (2b) using a suitable drift.- Remove the exhaust side camshaft oil seal.

Refitting ( Removing

) - Place the camshafts in their housings.- Place the camshaft gears in their housings and secure them without tightening the bolts.1. Fit the camshaft timing tools.

	Description	Code	Function
1	Templates	1.870.896.900	Engine tuning

Check that the tools are correctly fitted with the letters "A" and "S" in the housings in the inlet and exhaust camshafts.

1. Tighten the bolts fixing the camshaft gears to torque.

1. Fit the exhaust side camshaft front oil seal (1a) using the tool (1b).

	Description	Code	Function
1b	Fitting tool	1.870.896.800	Fitting exhaust camshaft oil seal

- Fit the inlet side camshaft plug.- Place the exhaust side camshaft toothed drive pulley in its housing and secure it without tightening the bolt.1. Place the cam angle sensor (1b) back in its housing and secure it tightening the bolt (1a) to torque.

- Remove the camshaft housing complete with support tool from the vice and separate them.

	Description	Code	Function
.	Support	1.860.470.001	Service cylinder head