850591 - 1060G80 Diesel electronic injection system CONTROL UNIT - R.R.

Removing ( Refitting ) - Position the vehicle on a lift.- Working via the boot, disconnect the negative battery terminal.    See in Op. 4450B02 Left FRONT WHEEL (one) - R.R.    See in Op. 7055B64 Engine compartment DUST SEAL in front wheel arch (one), left or right - R.R.1. Undo the retaining bolts.- Release the bracket from the engine oil radiator support pin.2. Remove the engine oil cooling radiator mounting bracket.3. Undo the upper retaining nuts.4. Move the engine cooling radiator out of the work area, securing in such a way that the pipes are not damaged.
1. Undo the retaining bolts.2. Disconnect the engine management control unit electrical connections.3. Remove the engine management control unit.
DescriptionConnector
2 Engine management control unitM010A
DescriptionConnector
2 Engine management control unitM010B
Refitting ( Removing ) - Fit the engine management control unit in the housing on the bodyshell.- Connect the electrical connections for the engine management control unit.
DescriptionConnector
.Engine management control unitM010A
DescriptionConnector
.Engine management control unitM010B
- Tighten the fixing bolts to torque.- Position the engine oil cooling radiator.- Tighten the upper mounting bracket fixing nuts.- Fit the lower engine cooling radiator mounting bracket and tighten the fixing bolts.    See in Op. 7055B64 Engine compartment DUST SEAL in front wheel arch (one), left or right - R.R.    See in Op. 4450B02 Left FRONT WHEEL (one) - R.R.- Connect the negative battery terminal.- Remove the vehicle from the lift.