78847 - 4410C10 front suspension stabilizer bar - r+r - check wheel geometry separately
Removing
(
Refitting
)
- Position the vehicle on a lift with the wheels perfectly straight.- Mark the position of the steering wheel in relation to the upper half-casing. See in Op. 4410D10 Front suspension FRAME - R.R.- Proceed with removing the front suspension frame without dismantling the chassis components at the bench; carry out the appropriate operation.1. Working on the retaining band (1a), disconnect the Duplex flexible pipe (1b) from the rigid pipe.2. Undo the fixing nuts.3. Remove the rigid pipe from the heat exchanger to the reservoir.
1. Undo the nuts (1a) fixing the headlamp adjustment sensor rod (1b).
1. Undo the bolts (1a) fixing the mounting bracket (1b) and remove the anti-roll bar (1c) complete with joints.
Refitting
(
Removing
)
- Fit the anti-roll bar complete with joints.- Tighten the fixing bolts on the frame to torque.
Value - daNm
Fastening
Component
Ø
.
(to crossmember) 3.5
Bolt
FRONT ANTI-ROLL BAR
M8
- Tighten the bolts fixing the headlamp adjustment sensor rod to the anti-roll bar and to the sensor.1. Check that the headlamp alignment adjustment sensor rod is fitted in the correct position.
- Fit the rigid pipe from the heat exchanger to the reservoir- Tighten the nuts fixing the pipe to the power assisted steering box.- Connect the flexible Duplex pipe to the rigid pipe. See in Op. 4410D10 Front suspension FRAME - R.R.- Proceed with refitting the front suspension frame; carry out the appropriate operation.
Removing
(
Refitting
)
- Position the vehicle on a lift with the wheels perfectly straight.- Mark the position of the steering wheel in relation to the upper half-casing. See in Op. 4410D10 Front suspension FRAME - R.R.- Proceed with removing the front suspension frame without dismantling the chassis components at the bench; carry out the appropriate operation.1. Working on the retaining band (1a), disconnect the Duplex flexible pipe (1b) from the rigid pipe.2. Undo the fixing nuts.3. Remove the rigid pipe from the heat exchanger to the reservoir.
