80279 - 7030B14 SUN ROOF - Dismantling and reassembly with assembly removed

Removing ( Refitting ) 1. Acting on the retaining springs (1a) remove the water drainage channel (1b). 1. Release the sliding blind from the housing in the direction shown by the arrow. 1. Undo the fixing bolts (1a) and remove the sunroof motor (1b). 1. Release the end of travel mounting on both sides. 1. Release the slide (1a) from the housing in the direction shown by the arrow and then release it from the drive cable (1b).- Release the drive cable and remove it. 1. Undo the fixing bolt (1a), on both sides, and remove the spoiler (1b).2. Release the spring, complete with support, and remove it. Refitting ( Removing ) - Check the condition of each individual component.1. Fit the spring, complete with support, in the housing.2. Position the spoiler (2a) and tighten the fixing bolts (2b). 1. Fit the drive cable (1a) in the housing and secure it to the slide (1b).- Place the slide in the end of travel position, until it is in the "tilted" position. 1. Fit the end of travel mounting on both sides. - Position the motor and secure it using the bolts. - Fit the sliding blind in the housing.- Position the water drainage channel in the housing until the click of the retaining springs is heard.