155805 - 3330C10 MASTER CYLINDER (PUMP) - R.R. - Bleed air from brakes separately

Removing ( Refitting ) - Open the boot, remove the cover on the left hand side and disconnect the negative battery lead.    See in Op. 1048A21 AIR INLET HOSE FROM INTAKE TO FILTER - R.R.    See in Op. 1048A28 vacuum air circuit resonator pipe - r+r1. Disconnect the connectors (1a) and (1b) for the braking system check control unit (1c) and remove the actual control unit.
DescriptionConnector
1a Braking system check control unit (NBA brake assistance)M052
DescriptionConnector
1b Braking system check control unit (NBA brake assistance)M052
1. Disconnect the electrical connection for the throttle casing.
DescriptionConnector
1 Integrated throttle casing actuatorN075
2. Undo the fixing bolts and remove the throttle casing
- Position a suitable container for collecting the brake fluid    See in Op. 3330C30 brake fluid reservoir - r + r and wash inside1. Disconnect the vacuum increase valve (1a) from the lower pipes (1b) to the brake servo and the intake hose.2. Undo the connectors (2a) for the rigid pipes (2b) between the brake pump (2c) and the ABS control unit and remove them.3. Undo the two nuts (3a) fixing the master cylinder and the braking system check control unit mounting bracket (3b) and remove the master cylinder.
Refitting ( Removing ) - Check the conditions of the seals on the master cylinder and, if necessary, replace them.1. Position the master cylinder (1a) and tighten the fixing nuts (1b).2. Position the rigid pipes (2b) between the ABS control unit and the brake pump tightening the connectors (2a) to the recommended torque.
Value - daNmFasteningComponentØ  
2a 1.4ConnectorPIPE FROM PUMP TO HYDRAULIC CONTROL UNITM10
3. Connect the lower pipes (3a) for the vacuum increase valve (3b).
    See in Op. 3330C30 brake fluid reservoir - r + r and wash inside1. Position the throttle casing and tighten the fixing bolts.
Value - daNmFasteningComponentØ  
1 9BoltBUTTERFLY VALVE CASE/S (MPI)M6
2. Connect the electrical connection for the throttle casing.
DescriptionConnector
2 Integrated throttle casing actuatorN075
1. Position the braking system check control unit (1c) and connect the connectors (1a) and (1b) for the control unit.
DescriptionConnector
1a Braking system check control unit (NBA brake assistance)M052
DescriptionConnector
1b Braking system check control unit (NBA brake assistance)M052
    See in Op. 1048A28 vacuum air circuit resonator pipe - r+r    See in Op. 1048A21 AIR INLET HOSE FROM INTAKE TO FILTER - R.R.    See in Op. 0010T64 Brake and/or clutch fluid - Check level and top up, if necessary- [PR0010T64]- Connect the negative battery terminal and position the cover on the left hand side of the luggage compartment.