209673 - 2135B72 ELECTRONIC AUTOMATIC GEARBOX INPUT RPM SENSOR - R.R.

Removing ( Refitting ) - Position the vehicle on a lift.    See in Op. 5530B10 BATTERY - R.R.- Make sure that the ignition key is in the OFF position, then disconnect the negative battery terminal.    See in Op. 7040D50 ENGINE COMPARTMENT UPPER SOUND INSULATION SHIELD - R.R.    See in Op. 7055B54 PROTECTION/GUARD under engine - R.R.    See in Op. 1048A28 vacuum air circuit resonator pipe - r+r- [PR2130B38]- [PR7055B39]- [PR1048A34]1. Undo the bolt and remove the electronic automatic transmission input rpm sensor from its housing.2. Disconnect the electrical connection (2a) and remove the electronic automatic transmission input rpm sensor (2b).
Refitting ( Removing ) - Place the electronic automatic transmission input rpm sensor back in its housing and tighten it to the recommended torque.
Value - daNmFasteningComponentØ  
.-BoltAUTOMATIC GEARBOX INPUT RPM SENSOR ELECTR.-
- Connect the electrical connection to the electronic automatic transmission input rpm sensor.- [PR1048A34]- [PR7055B39]- [PR2130B38]    See in Op. 1048A28 vacuum air circuit resonator pipe - r+r    See in Op. 7055B54 PROTECTION/GUARD under engine - R.R.    See in Op. 7040D50 ENGINE COMPARTMENT UPPER SOUND INSULATION SHIELD - R.R.- Connect the negative battery terminal.- Remove the vehicle from the lift.