190149 - 2130A38 Automatic transmission HEAT EXCHANGER - R.R.

Refitting

    See in Op. 1048A21 AIR INLET HOSE FROM INTAKE TO FILTER - R.R.    See in Op. 1048A28 vacuum air circuit resonator pipe - r+r    See in Op. 1016A42 LEFT CYLINDER HEAD IGNITION COIL COVER - R.R.    See in Op. 1048A11 COMPLETE AIR FILTER -R.R.- Raise the vehicle on the lift.    See in Op. 7055B54 PROTECTION/GUARD under engine - R.R.- Position a suitable container for collecting the engine coolant.1. Open the rapid attachment band (1a) and disconnect the lower pipe (1b) from the radiator.

- Position a container to collect the automatic transmission fluid.1. Undo the plug and drain the transmission fluid.

1. Open the bands (1a) for the heat exchanger (1c) coolant inlet and outlet pipes (1b).

1. Undo the fixing bolt (1a) and remove the heat exchanger (1b) keeping the seal (1c) that is underneath.

Refitting ( Removing ) - Position a new seal and fit the heat exchanger, making sure that the positioning tab is correctly engaged.- Position a new flexible washer and tighten the bolt fixing the heat exchanger to the recommended torque.

	Value - daNm	Fastening	Component	Ø
.	3.6	Bolt	HEAD EXCHANGER FIXING BOLTS	M12 X 117

    See in Op. 7055B54 PROTECTION/GUARD under engine - R.R.- Lower the vehicle- Connect the coolant inlet and outlet pipes and close the retaining bands.    See in Op. 0010T44 AUTOMATIC TRANSMISSION FLUID - Change    See in Op. 1048A11 COMPLETE AIR FILTER -R.R.    See in Op. 1016A42 LEFT CYLINDER HEAD IGNITION COIL COVER - R.R.    See in Op. 1048A28 vacuum air circuit resonator pipe - r+r    See in Op. 1048A21 AIR INLET HOSE FROM INTAKE TO FILTER - R.R.- Connect the negative battery terminal.    See in Op. 0010T21 ENGINE COOLANT - Check density and top up if necessary-    See in Op. 7040D50 ENGINE COMPARTMENT UPPER SOUND INSULATION SHIELD - R.R.- Remove the vehicle from the lift.