193016 - 5580A76 Braking system check control unit - R.R.

Removing ( Refitting ) - Open the boot, remove the cover on the left hand side and disconnect the negative battery lead.    See in Op. 1048A28 vacuum air circuit resonator pipe - r+r1. Open the retaining band and disconnect the automatic transmission electrical connectors.
DescriptionConnector
1 Automatic transmission solenoid valvesL050A
DescriptionConnector
1 Automatic transmission solenoid valvesL050B
DescriptionConnector
1 Automatic transmission solenoid valvesL050C
1. Disconnect the connectors (1a) and (1b) for the braking system check control unit (1c) and remove the actual control unit.
DescriptionConnector
1a Braking system check control unit (NBA brake assistance)M052
DescriptionConnector
1b Braking system check control unit (NBA brake assistance)M052
Refitting ( Removing ) - Position the braking system check control unit and connect the connectors to the actual control unit.
DescriptionConnector
.Braking system check control unit (NBA brake assistance)M052
DescriptionConnector
.Braking system check control unit (NBA brake assistance)M052
- Connect the electrical connectors for the automatic transmission and close the retaining band.
DescriptionConnector
.Automatic transmission solenoid valvesL050A
DescriptionConnector
.Automatic transmission solenoid valvesL050B
DescriptionConnector
.Automatic transmission solenoid valvesL050C
    See in Op. 1048A28 vacuum air circuit resonator pipe - r+r- Connect the negative battery terminal and position the cover on the left hand side of the luggage compartment.
If the control unit is being replaced, carry out the calibration procedure using a diagnostic station.