214204 - 1056B17 THROTTLE CASING WITH D.V.L. - R.R.

Removing ( Refitting )     See in Op. 5530B10 BATTERY - R.R.- Make sure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).- [7040D12]- [7040D14]    See in Op. 7040D50 ENGINE COMPARTMENT UPPER SOUND INSULATION SHIELD - R.R.    See in Op. 1048A28 vacuum air circuit resonator pipe - r+r1. Disconnect the electrical connection from the throttle casing with D.V.L.
DescriptionConnector
1 Integrated throttle casing actuatorN075
2. Undo the bolts (2a) and remove the throttle casing with D.V.L. (2b) complete with gasket.
Refitting ( Removing ) - Fit the throttle casing with D.V.L. complete with gasket and secure it tightening the bolts to the recommended torque.
Value - daNmFasteningComponentØ  
.(Air chamber side) 0.8 - 1.1BoltBUTTERFLY VALVE CASE/S (MPI)M6
When refitting, the learning procedure for the throttle casing with D.V.L. must be repeated )[PR1056B81] CARRYING OUT the electronic injection/ignition (single) CONTROL UNIT SELF-LEARNING procedure).
- Connect the electrical connection to the throttle casing with D.V.L.
DescriptionConnector
.Integrated throttle casing actuatorN075
    See in Op. 1048A28 vacuum air circuit resonator pipe - r+r    See in Op. 7040D50 ENGINE COMPARTMENT UPPER SOUND INSULATION SHIELD - R.R.- [7040D14]- [7040D12]- Connect the negative battery terminal.