79356 - 5505B20 REAR DOOR built in wiring (one), left or right - R.R. with water protection or support frame removed

Removing ( Refitting ) 1. Disconnect the electrical connectors (1a), (1b), (1c), (1d).

	Description	Connector
1a	Switch on driver's rear exterior handle	I024

	Description	Connector
1a	Switch on passenger side rear exterior handle	I025

	Description	Connector
1b	Left rear door lock geared motor	N055A

	Description	Connector
1b	Right rear door lock geared motor	N056A

	Description	Connector
1c	Left rear electric window motor	N065

	Description	Connector
1c	Right rear electric window motor	N066

	Description	Connector
1d	Speaker in left rear door	P040

	Description	Connector
1d	Speaker in right rear door	P041

	Description	Connector
1b	Left rear door lock geared motor	N055B

	Description	Connector
1b	Right rear door lock geared motor	N056B

2. Lift up the protective tab (2a) and disconnect the electrical connector (2b).

	Description	Connector
2b	Left rear door coupling	D035

	Description	Connector
2b	Right rear door coupling	D036

3. Release the electrical wiring from the retaining springs and remove it from the housing. 1. Disconnect the electrical connectors (1a), (1b) and (1c) and keep the passive entry aerial (1d), the front door locking/unlocking signal unit (1e) and the front door locking/unlocking switch (1f).

	Description	Connector
1a	Driver's rear door locking/unlocking switch	I028

	Description	Connector
1a	Passenger rear door locking/unlocking switch	I029

	Description	Connector
1b	RF aerial on left rear door for passive entry (NPE)	P096

	Description	Connector
1b	RF aerial on right rear door for passive entry (NPE)	P097

	Description	Connector
1c	Unit signalling driver's rear door locking/unlocking	E038

	Description	Connector
1c	Unit signalling passenger rear door locking/unlocking	E039

Refitting ( Removing ) - Check that the wiring is not damaged and that the individual conducts are correctly fastened to the connections.- If necessary, carry out continuity tests.1. Keep the passive entry aerial (1a), the front door locking/unlocking signal unit (1b) and the front door locking/unlocking switch (1c) and connect the connectors (1d), (1e) and (1f).

	Description	Connector
1d	Driver's rear door locking/unlocking switch	I028

	Description	Connector
1d	Passenger rear door locking/unlocking switch	I029

	Description	Connector
1e	RF aerial on left rear door for passive entry (NPE)	P096

	Description	Connector
1e	RF aerial on right rear door for passive entry (NPE)	P097

	Description	Connector
1f	Unit signalling driver's rear door locking/unlocking	E038

	Description	Connector
1f	Unit signalling passenger rear door locking/unlocking	E039

1. Connect the electrical connectors (1a), (1b), (1c), (1d).