96317 - 1092G10 Engine components single drive BELT - R.R.

Removing ( Refitting ) - Position the vehicle on a lift.    See in Op. 4450B04 Right FRONT WHEEL (one) - R.R.- Raise the vehicle on the lift.    See in Op. 7055B64 Engine compartment DUST SEAL in front wheel arch (one), left or right - R.R.    See in Op. 7055B42 FRONT WHEEL ARCH LINER (one), left or right - R.R.1. Use a spanner on the moving tensioner (1a) in the direction illustrated in the diagram until the centering openings (1b) are aligned, then insert a 4 mm diameter retaining pin (1c) to keep the tensioner in this "slack belt" position.2. Release and remove the auxiliary shaft drive belt.
Refitting ( Removing ) - Fit the auxiliary shaft drive belt on the pullies.- Keeping the moving tensioner in this "slack belt" position using a spanner, remove the retaining pin.    See in Op. 7055B42 FRONT WHEEL ARCH LINER (one), left or right - R.R.    See in Op. 7055B64 Engine compartment DUST SEAL in front wheel arch (one), left or right - R.R.    See in Op. 4450B04 Right FRONT WHEEL (one) - R.R.- Remove the vehicle from the lift.