177973 - 4420C80 Rear suspension CAMBER ROD - R.R.

Refitting

    See in Op. 7055B45 Right rear wheel arch liner - R.R.    See in Op. 1076B20 Rear exhaust SILENCER - R.R.    See in Op. 4420D10 REAR SUSPENSION AXLE - R.R.    See in Op. 4420C82 Rear suspension CAMBER ROD - R.R. WITH SUSPENSION CROSSMEMBER REMOVED Refitting ( Removing )     See in Op. 4420C82 Rear suspension CAMBER ROD - R.R. WITH SUSPENSION CROSSMEMBER REMOVED    See in Op. 4420D10 REAR SUSPENSION AXLE - R.R.    See in Op. 1076B20 Rear exhaust SILENCER - R.R.    See in Op. 7055B45 Right rear wheel arch liner - R.R.    See in Op. 4450B13 Rear WHEELS (two) - R.R.- Place the vehicle in Standard "A" conditions, in other words with the vehicle mass complete, spare wheel, tool kit, all supplies and accessories (oil, engine coolant, etc.) and a full fuel tank.- Check that the tyre inflation pressure is correct.- Position the vehicle on a support so that the wheels are resting on the ground. - Check that after the vehicle has been placed in standard "A" conditions, the measurement "D"-"C" corresponds to the figure given in the table below.

	Subject	Value
.	Rear wheel geometry	mm
-	D - C	21 ± 5
-	Standard A	-

- Tighten the bolts fixing the rod to the steering knuckle to torque.

	Value - daNm	Fastening	Component	Ø
.	(Steering knuckle) 11	Bolt	HOUSING LINK	M12X1.25

- Tighten the bolts fixing the camber rod to the rear axle to torque.

	Value - daNm	Fastening	Component	Ø
.	(Crossmember side) 9	Nut	HOUSING LINK	M12X1.25

    See in Op. 4450A40 REAR WHEEL GEOMETRY - Check using optical equipment - Includes rear wheel toe-in adjustment if necessary