108798 - 1820B38 CLUTCH HYDRAULIC ACTUATOR/OPERATING CYLINDER - R.R. and bleed air with clutch removed
Removing
(
Refitting
)
1. Undo the fixing bolts (1a), release the rubber cap (1b) for the rigid pipe from the bell housing, then remove the clutch hydraulic operating cylinder (1c).
Refitting
(
Removing
)
- Clean the matching surfaces between the cylinder and the gearbox thoroughly.- Apply silicon sealant to the matching surfaces of the hydraulic actuator and the gearbox. | Take care when fitting the actuator on the main gearbox shaft no to damage the seal. |