145795 - 5510C36 RPM SENSOR - R.R.

Removing ( Refitting ) - Position the vehicle on the lift.- Make sure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).    See in Op. 7055B54 PROTECTION/GUARD under engine - R.R.    See in Op. 7040D50 ENGINE COMPARTMENT UPPER SOUND INSULATION SHIELD - R.R.1. Disconnect the rpm sensor electrical connector.
DescriptionConnector
1 Rpm sensorK046
- Raise the vehicle on the lift.    See in Op. 7055B54 PROTECTION/GUARD under engine - R.R.    See in Op. 1076B68 EXHAUST PIPE FLEXIBLE SECTION - R.R.1. Undo the bolt (1a), release the electrical wiring from the retaining bands on the modular intake chamber and remove the rpm sensor (1b).
Refitting ( Removing ) - Position the rpm sensor in its housing and secure it using the bolt.- Secure the electrical wiring to the modular intake chamber using the retaining bands.    See in Op. 7055B54 PROTECTION/GUARD under engine - R.R.- Lower the vehicle on the lift.    See in Op. 7040D50 ENGINE COMPARTMENT UPPER SOUND INSULATION SHIELD - R.R.- Connect the rpm sensor electrical connector.
DescriptionConnector
.Rpm sensorK046
- Connect the negative battery terminal.- Remove the vehicle from the lift.