174930 - 4130B94 DUPLEX PIPES from cooling coil or heat exchanger radiator - R.R.

Refitting

    See in Op. 1048A28 vacuum air circuit resonator pipe - r+r    See in Op. 1048A21 AIR INLET HOSE FROM INTAKE TO FILTER - R.R.    See in Op. 1048A10 COMPLETE AIR FILTER -R.R. - Release the pipes from the plastic retaining bands.1. Release the air conditioning system pipe (1a) from the band (1b).2. Undo the nuts fixing the air filter mounting bracket.3. Disconnect the duplex pipes (3a) from the cooling coil (3b).

Position a suitable container under the pipes and collect the oil that comes out of the pipes.

    See in Op. 7055B54 PROTECTION/GUARD under engine - R.R.    See in Op. 4450B02 Left FRONT WHEEL (one) - R.R.    See in Op. 7055B42 FRONT WHEEL ARCH LINER (one), left or right - R.R.1. Undo the connector for the duplex pipe on the steering box.2. Undo the nuts (2a) fixing the pipe mounting brackets (2b) to the suspension crossmember.3. Disconnect the flexible pipe from the rigid pipe behind the steering box.4. Remove the duplex pipes from the lower part of the vehicle.

Refitting ( Removing ) - Position the duplex pipes in the housing on the crossmember.- Tighten the nuts fixing the pipe mounting brackets to the suspension crossmember.- Tighten the connector for the duplex pipe on the steering box.

	Value - daNm	Fastening	Component	Ø
.	1.5	Nut	PIPE POWER ASSISTED STEERING BOX/HEAT EXCHANGER	M8

- Connect the flexible pipe to the rigid pipe.    See in Op. 7055B42 FRONT WHEEL ARCH LINER (one), left or right - R.R.    See in Op. 4450B02 Left FRONT WHEEL (one) - R.R.    See in Op. 7055B54 PROTECTION/GUARD under engine - R.R.- Connect the duplex pipes to the cooling coil.- Fit the air filter mounting bracket and tighten the fixing nuts.- Secure the air conditioning system pipe to the air filter mounting bracket.     See in Op. 1048A10 COMPLETE AIR FILTER -R.R.    See in Op. 1048A21 AIR INLET HOSE FROM INTAKE TO FILTER - R.R.    See in Op. 1048A28 vacuum air circuit resonator pipe - r+r - Remove the vehicle from the lift.- Refill the power assisted steering system using the appropriate fluid.

	Description	Qty.	Component	Type	Classification
.	TUTELA HP 20	-	POWER ASSISTED STEERING CIRCUIT	Oil	ATF DEXRON III

- Continue with the bleeding procedure following the instructions given below.- With the front wheels raised off the ground and the engine switched off, carry out 4 or 5 complete rotations of the steering wheel (left and right).- Check and, if necessary, top up the power assisted steering fluid level.- Position the vehicle on the ground and start up the engine.- Carry out 4 or 5 complete rotations of the steering wheel (left and right).- If necessary, top up the power assisted steering fluid level.    See in Op. 7040D50 ENGINE COMPARTMENT UPPER SOUND INSULATION SHIELD - R.R.