74567 - 1004D10 POWER UNIT (manual gearbox), removed - Separate and reassemble

Removing ( Refitting ) 1. Disconnect the electrical connections from the starter motor.
DescriptionConnector
1 Starter motorA020A
DescriptionConnector
1 Starter motorA020B
2. Undo the bolts (2a) and remove the starter motor (2b).
- Undo the gearbox and differential oil drain plug.
Collect the fluid in a suitable container
1. Undo the three bolts (1a) and remove the intermediate driveshaft (1b).
1. Undo the bolts (1a) and remove the lower flywheel protection (1b).2. Undo the bolts fixing the gearbox-differential unit to the crankcase sump.3. Undo the nut fixing the gearbox-differential unit to the cylinder block/crankcase.
1. Undo the upper bolts (1a) and the nut (1b) fixing the gearbox-differential unit to the cylinder block/crankcase.
1. Separate the gearbox-differential unit from the engine.
1. Fit the flywheel lock.
DescriptionCodeFunction
1 Counter-torque1.860.846.000Engine flywheel lock
2. Undo the bolts (2a) and remove the pressure plate (2b) and the clutch disc (2c).
Refitting ( Removing ) 1. Position the pressure plate (1a), complete with clutch disc (1b) in its housing using the tool (1c) and secure it tightening the bolts (1d) to the recommended torque.
DescriptionCodeFunction
1c Clutch locating tool1.870.447.000Tool for centering clutch plate on engine flywheel
Value - daNmFasteningComponentØ  
1d 2.8BoltCLUTCH ASSEMBLYM8
2. Remove the flywheel lock.
DescriptionCodeFunction
2 Counter-torque1.860.846.000Engine flywheel lock
- Reposition the gearbox-differential unit and secure it tightening the bolts to the recommended torque.
Value - daNmFasteningComponentØ  
.8BoltMANUAL GEARBOX/DIFFERENTIALM12 X 1.25
Value - daNmFasteningComponentØ  
.5.5BoltMANUAL GEARBOX/DIFFERENTIALM10 X 1.25
- Fit the lower engine flywheel guard and secure it using the bolts.- Reposition the intermediate driveshaft in its housing and secure it tightening the bolts to the recommended torque.
Value - daNmFasteningComponentØ  
.0.8BoltINTERMEDIATE DRIVE SHAFTM6
- Fit the starter motor and secure it tightening the bolts to the recommended torque.
Value - daNmFasteningComponentØ  
.7BoltSTARTER MOTORM8
- Connect the electrical connections from the starter motor.
DescriptionConnector
.Starter motorA020A
DescriptionConnector
.Starter motorA020B
    See in Op. 0010T40 MANUAL GEARBOX OIL - Change