75037 - 1056B82 Injection/ignition system CONTROL UNIT (one) - R.R.

Removing ( Refitting ) - Make sure that the ignition key is in the OFF position, then disconnect the negative battery terminal.    See in Op. 1016A40 Ignition COIL COVER on cylinder head - R.R.1. Release the dashboard/engine coupling from the mounting bracket.2. Disconnect the electrical connections (2a) and (2b) from the injection/ignition system control unit.
DescriptionConnector
2a Engine management control unitM010A
DescriptionConnector
2b Engine management control unitM010B
1. Undo the nuts (1a) and remove the injection/ignition system control unit (1b).
Refitting ( Removing ) - Proceed with the refitting following the instructions given below.
If the engine management control unit is being replaced, the control unit learning procedure must be carried out at the end of the fitting operation.
    See in Op. 1056B81 CARRYING OUT SELF-LEARNING PROCEDURE FOR BASIC ELECTRONIC INJECTION/IGNITION (SINGLE) CONTROL UNIT- Position the injection/ignition system control unit on the bracket and secure it using the nuts.- Connect the electrical connections to the injection/ignition system control unit.
DescriptionConnector
.Engine management control unitM010A
DescriptionConnector
.Engine management control unitM010B
- Position the dashboard/engine coupling on the mounting bracket.    See in Op. 1016A40 Ignition COIL COVER on cylinder head - R.R.- Connect the negative battery terminal.