79403 - 5510C45 DETONATION SENSOR (one- remaining) R.R. after Op. 5510C44

Removing ( Refitting ) - Make sure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).    See in Op. 7040D50 ENGINE COMPARTMENT UPPER SOUND INSULATION SHIELD - R.R.1. Disconnect the detonation sensor electrical connector.
DescriptionConnector
1 Detonation sensor - 2K051
    See in Op. 1016A40 Ignition COIL COVER on cylinder head - R.R.    See in Op. 1048A28 vacuum air circuit resonator pipe - r+r    See in Op. 1048A48 HOSE BETWEEN RESONATOR AND THROTTLE CASING - R.R.    See in Op. 1056B14 THROTTLE CASING - R.R.1. Undo the bolt (1a) and remove the detonation sensor (1b).
Refitting ( Removing ) - Place the detonation sensor in its housing and secure it using the bolt.    See in Op. 1056B14 THROTTLE CASING - R.R.    See in Op. 1048A48 HOSE BETWEEN RESONATOR AND THROTTLE CASING - R.R.    See in Op. 1048A28 vacuum air circuit resonator pipe - r+r    See in Op. 1016A42 LEFT CYLINDER HEAD IGNITION COIL COVER - R.R.- Connect the detonation sensor electrical connector.
DescriptionConnector
.Detonation sensor - 2K051
    See in Op. 7040D50 ENGINE COMPARTMENT UPPER SOUND INSULATION SHIELD - R.R.- Connect the negative battery terminal.