95880 - 1088D36 CONNECTOR ON CRANKCASE FOR CYLINDER HEAD/CRANKCASE WATER CIRCUIT HOSE WITH THERMOSTAT CLOSED - R.R.
Removing ( Refitting ) - Position the vehicle on a lift.- Open the boot, remove the cover on the left hand side and disconnect the negative battery lead. See in Op. 7040D50 ENGINE COMPARTMENT UPPER SOUND INSULATION SHIELD - R.R. See in Op. 7055B54 PROTECTION/GUARD under engine - R.R. See in Op. 1016A40 Ignition COIL COVER on cylinder head - R.R. See in Op. 1048A28 vacuum air circuit resonator pipe - r+r See in Op. 1048A48 HOSE BETWEEN RESONATOR AND THROTTLE CASING - R.R. See in Op. 1056B82 Injection/ignition system CONTROL UNIT (one) - R.R. See in Op. 1056B14 THROTTLE CASING - R.R. See in Op. 1056B87 INJECTION/IGNITION CONTROL UNIT MOUNTING - R.R. See in Op. 1072B10 INTAKE MANIFOLD - R.R. and Replace gasket See in Op. 1072D50 DEVICE (V.I.S.) with adjustable air ducts - R.R. 1. Undo the bolts (1a), disconnec the band (1b) on the hose (1c) and remove the connector on the crankcase for the cylinder head/crankcase water circuit with the thermostat closed (1d).2. Remove the O-ring.Collect the coolant that comes out in a suitable container. |
Refitting
(
Removing
)
- Position the connector on the crankcase for the cylinder head/crankcase water circuit with the closed thermostat, complete with O-ring, in its housing, then secure it using the bolts.
See in Op. 1072D50 DEVICE (V.I.S.) with adjustable air ducts - R.R. See in Op. 1072B10 INTAKE MANIFOLD - R.R. and Replace gasket See in Op. 1056B87 INJECTION/IGNITION CONTROL UNIT MOUNTING - R.R. See in Op. 1056B14 THROTTLE CASING - R.R. See in Op. 1056B82 Injection/ignition system CONTROL UNIT (one) - R.R. See in Op. 1048A48 HOSE BETWEEN RESONATOR AND THROTTLE CASING - R.R. See in Op. 1048A28 vacuum air circuit resonator pipe - r+r See in Op. 1016A40 Ignition COIL COVER on cylinder head - R.R. See in Op. 0010T21 ENGINE COOLANT - Check density and top up if necessary See in Op. 7055B54 PROTECTION/GUARD under engine - R.R.
See in Op. 7040D50 ENGINE COMPARTMENT UPPER SOUND INSULATION SHIELD - R.R.- Connect the negative battery terminal, then close the boot.- Remove the vehicle from the lift.