842223 - 2130B36 Automatic transmission SOLENOID VALVE COVER - R.R.

Removing ( Refitting ) - Position the vehicle on a lift.
Before proceeding with the operation of removing the automatic transmission system wiring, position the gear lever in "N"
- Open the boot, remove the cover on the left hand side and disconnect the negative battery lead.    See in Op. 7040D50 ENGINE COMPARTMENT UPPER SOUND INSULATION SHIELD - R.R.    See in Op. 1016A40 Ignition COIL COVER on cylinder head - R.R.    See in Op. 1048A21 AIR INLET HOSE FROM INTAKE TO FILTER - R.R.    See in Op. 1048A23 Cold AIR INTAKE for air filter - R.R.    See in Op. 1048A28 vacuum air circuit resonator pipe - r+r    See in Op. 1048A10 COMPLETE AIR FILTER -R.R.- Raise the vehicle on the lift.    See in Op. 7055B42 FRONT WHEEL ARCH LINER (one), left or right - R.R.- Left side    See in Op. 7055B54 PROTECTION/GUARD under engine - R.R.- Position a container to collect the automatic transmission fluid.1. Undo the plug and drain the transmission fluid
1. Undo the lower bolts (1a) fixing the solenoid valve unit cover (1b).
- Lower the vehicle1. Release the air conditioning system pipe (1b) from the retaining clips (1a)2. Undo the upper bolts (2a) fixing the solenoid valve unit cover (2b) and remove it taking care not to damage the actual cover and the gearbox casing.
Refitting ( Removing ) - Clean any selant residues from the contact surfaces of the automatic transmission solenoid valve unit cover.- Apply a bead of suitable silicon sealant 1.0 - 1.5 mm thick along the edge of the solenoid valve unit cover, removing any excees from inside the actual cover.
Take care not to foul the contact surfaces between the cover and the gearbox casing with oil.
1. Place the gear selector solenoid valve unit cover back in its housing and secure it tightening the bolts to the recommended torque.
Value - daNmFasteningComponentØ  
1 1.3BoltSOLENOID VALVE COVER FIXING, BOLTM8 X 15
- Secure the air conditioning system pipe to the retaining clips on the engine support frame.- Position the gearbox oil plug- Lower the vehicle    See in Op. 0010T44 AUTOMATIC TRANSMISSION FLUID - Change    See in Op. 1048A10 COMPLETE AIR FILTER -R.R.    See in Op. 1048A28 vacuum air circuit resonator pipe - r+r    See in Op. 1048A23 Cold AIR INTAKE for air filter - R.R.    See in Op. 1048A21 AIR INLET HOSE FROM INTAKE TO FILTER - R.R.    See in Op. 1016A40 Ignition COIL COVER on cylinder head - R.R.    See in Op. 7040D50 ENGINE COMPARTMENT UPPER SOUND INSULATION SHIELD - R.R.    See in Op. 7055B42 FRONT WHEEL ARCH LINER (one), left or right - R.R.- Left side    See in Op. 7055B54 PROTECTION/GUARD under engine - R.R.- Connect the negative battery lead, then close the boot.- Remove the vehicle from the lift.